2021年8月1日 · Recently replaced fork bearings on the Reverse/6 fork. Did successful basic settings, car now drives normally up to gear number 6 and then it flashes a spanner. From then on it starts selecting only even number gears ( 2.4.6). On checking the errors I am getting a P073A, P177C and P073C.

2019年1月11日 · a friend of mine got a VW Touran from 2010 with 0AM 7-Gear DSG Transmission. While accelerating or even if he goes down from acceleration the car is shaking and the gears are going in very hard. ODIS showed us two fault codes: P175E P175D Both saying Clutch is opening or closing unintenionally.

2024年12月13日 · OBD codes P175D (Clutch 1 opens unintentionally), P175E (Clutch 1 closes unintentionally), and P177B (Clutch 1 tolerance limit reached) highlight critical issues with Clutch 1 in the transmission system. These faults can affect drivability and lead to costly repairs if not addressed promptly.

2021年10月19日 · It may be a clutch problem - it can be confirmed by some values, but readed only BEFORE basic settings was done! Than, if you want to try basic settings and this go wrong, you can restore old settigs by writing old dump with PCMFlash again (EEPROM only).

Compare the measured resistance to the specified range for the actuator. If the resistance is too high or too low, it indicates an issue with the actuator's electrical circuit. Pressure Test: Connect a pressure gauge to the clutch actuator's pressure port and activate the actuator.

It appears that the error code 175E is indicating an issue with the clutch 1 closing unintentionally. This could be caused by a faulty clutch actuator, a problem with the clutch control wiring, or a problem with the transmission control module (TCM).

2024年12月11日 · Push Robs (Actuators) has two versions with different lengths: 1st generation (part number 0AM325091E, Mechatronic part number 0AM325025D) is 101mm, 2nd generation (part number 0AM325091F) is 99mm. They are not interchangeable. If you have the wrong version, remove the heads from the rob and swap those two heads to your original rob.

2021年12月18日 · Took it to two garages who both did diagnostics to find Fault Code : p175e relating to clutch 1 closing unintentionally. Recommendation was new clutch. Had a new clutch fitted but problem did not stop and had the same fault code. Had mechatronic unit sent off to be checked and no problems were detected.

This bulletin contains repair instructions for when the gearbox malfunction message has appeared with one or more of the following dtcs P176F00, P176E00 or P175E00. Related OBD-II Error Codes Vehicles impacted by this bulletin may show the following OBD DTC .

2) have you had the transmission control module scanned for faults using a VW specific scan tool? 3) what were the faults? 4) does the car move in any gear, forward or reverse?