2023年4月8日 · Use a good coax loss chart or calculator when selecting your coax. Be aware that there are several different types of most of these RG type coaxes and you can't assume that …

2011年12月17日 · Look up a coax specification chart online and decide what's best for your systems. RG8 is a heavy cable, but compared to RG58 or RG8X it has much lower signal loss …

2011年4月12日 · Without a doubt, if you are not buying new coax and want to use the coax on-hand, use the RG-213 for the Yaesu and the RG-8X for the Ranger. The 8X is not optimal for …

2011年7月17日 · The only thing I'll add is, particularly if you just drill a hole through the wall and shove the coax through, but sure to use a "drip loop". It's one of those things that is obvious in …

2008年3月30日 · You want 100% shielding on the coax, to keep noise from further degrading the signal from the antenna. Cheaper coax cables also may not be made quite to spec, so even …

2006年4月30日 · If this is just for receiving, it shouldn't pose a problem but if you plan on transmitting as well, you can either run the coax through a wall plate and go from there or you …

2012年7月30日 · I was looking at this - 100ft RG8x Coax UHF (PL259) Male to Male 50 ohm Antenna Cable - R-U100 for running a temp. jpole antenna. I didn't see any 75ft which would …

2020年4月15日 · Then I used a 2ft 50 ohm RG174 coax and calibrated that with a 50 ohm load and sweeped the HP-1 using that coax. Then I finally used a 75 ohm RG6 coax at about the …

2019年3月13日 · The loss compared to RG6 depends of the lenght of the coax. At 25 feet you have a 3dB loss at 900MHz in the RG8U and 1.5dB with a RG6. A 1.5dB difference are not …

2023年12月31日 · Hey guys, after doing some reading in the manual for my Uniden BC125AT scanner, I read where it said to use RG8 or RG58 coax cable if you're going to be using an …