2017年1月25日 · I had to replace my Prius 2nd Gen Bleeder Valve because it was completed corroded and the 6mm hex key wouldn't turn it. I hammered a flat screwdriver into the old plastic bleeder valve and turned it counterclockwise to take it off. Here's a photo of the new parts (bleeder valve and O Ring), part numbers, and location of the bleeder valve.

2014年10月17日 · Simply remove the valve, detach the dangling hose from the old valve and attach to the new valve, then shove the valve back into the engine compartment and reattach the hose to the tank port. 9) If/when you open the top vent port on the radiator - usually when refilling the fluid - be VERY careful when loosening/tightening.

radiator by pressing the inlet and outlet radiator hoses several times by hand. If the coolant level goes down, add more coolant. When Coolant Starts Coming Out of Bleed Hose, tighten Bleed Valve with 6mm Hex. Replace Radiator Cap. Slowly pour coolant into the Radiator Reservoir until it reaches the full line.

*3 Radiator Drain Cock Plug *4 Air Release Valve 4. ADD COOLANT (for Engine) (a) Tighten the radiator drain cock plug. (b) Tighten the cylinder block drain cock plug. Torque: 13 N·m (130 kgf·cm, 9ft·lbf) (c) Remove the reservoir tank cap. (d) Connect the hose to the air release valve. (e) Loosen the air release valve.

(a) Install the upper radiator support with the 4 bolts. Torque: 13 N·m (133 kgf·cm, 10ft·lbf) (b) Install the 2 cushions to the radiator support RH and radiator support LH. (c) Install the radiator support RH and radiator support LH wit h the 2 bolts. Torque: 19 N·m (194 kgf·cm, 14ft·lbf) (d) Connect the 2 horn connectors.

10mm and 12mm deep sockets for the valve mount Optional tools (makes it easier): Cable operated hose clamp pliers Link Spill Free Radiator Filler Kit ($20-$25 on amazon) Here is a video showing valve inside and outside of Prius. One poster mentioned that clamping the three hoses allows you to skip the draining and refilling of coolant.

2019年11月11日 · Put on the radiator cap and let it run for a minute. Turn off the car and wait til it cools. 2. When the car is completely cool (will be a few hours), open the radiator cap and fill the coolant again until it's full. Repeat a few more mornings and you should be good.

2024年4月5日 · I need to replace the 3-Way Coolant Flow Control Valve Water Valve Replacement in my 2008 Toyota Prius. The price quoted to me was $900 which sounds excessive. Is the picture below the proper part? Will mechanics allow me to bring the part with me and use it for their replacement? TIA View attachment 253542

9. REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY (a) Remove the screw and clamp. Text in Illustration *1 Clamp (b) Remove the heater radiator unit sub-assembly as shown in the illustration. NOTICE: Prepare a drain pan or cloth in case the cooling water leaks. 10. REMOVE CONSOLE MOUNTING BRACKET LH (a) Remove the screw and console mounting bracket LH.

2018年1月16日 · Any help appreciated. I've watched and read all coolant valve threads. 3 years ago my coolant valve was replaced but check engine light never went off, mechanics said they did everything and are stumped, except for replacing storage tank etc. Now it's time to get inspected, so I figured I'd replace the valve again myself.