2013年8月10日 · Is it fine to hold round stock just on flat walls of a vice or should I taper them like I did in the pic? I thought a 10 degree taper would help keep the part from pulling up?

2006年11月10日 · What are some good ways to hold round things in a square vise? V Blocks? Will V Blocks hold the part securely without deforming the material when machining? Get one …

One way of holding a round bar in a vice is to use a spacer between the round part and one face of the vice with a V-shape in it. It is quite easy to make V-blocks whose width is less that the height of the face of the vice just for this purpose.

2019年5月8日 · Does anyone have a clever way to clamp a piece of round stock lengthwise in the mill vise if the centerline of the object is higher than the vise jaws? I need to drill and ream some holes in 5" OD pipe, and would normally secure it with hold downs, but wondered if someone had some great trick for doing it more easily.

Choose from our selection of round vises, including hand-held vises, pipe vises, and more. Same and Next Day Delivery.

2010年12月4日 · Holding Round Parts for Concentric Milling? The long spool type part should be okay to clamp in a vise, if the spool flanges are all the same diameter, and if the vise is long enough to contain the entire length of the part. The bottom part looks very crushable, and a vise would not work directly on that.

Features: Machine vice for holding round workpieces. Reversible mount for smaller bar diameters. Can be used horizontally or vertically Specifications: Capacity: 10-80mm round Base: 230x161mm (Horizontal) Base: 161x135mm (Vertical) Jaw width: 100mm

Prismatic moveable jaw with 1 horizontal and 1 vertical vee for holding round bar. The fixed jaw has a threaded hole at each end to facilitate the fitting of an end stop. Click the Specification tab to see the dimensions. Click the More tab to see how it works. The Type 2 Precision Tool Vice uses a rack and pin-block locking method.

Precise Vise For Holding Shafts & Round work - RSV-400. The vise is for clamping round workpieces with diameters from 25/64" to 2-1/2". For use on a machine or drill press. The jaw plates are case-hardened and heat treated to Rockwell C 55-60. The vise body and 2 moveable jaws are made of semi-steel. Vises can be set up in two positions.

2015年2月19日 · What is the best way to hold round work in a milling vice like a Kurt? because they get in the way of the drill chuck or spindle w/R8. Is it OK to sit these short tubes on parallels fairly low in the vise and clamp? Can I use angle iron and clamp the tube on each end with vise grips? What is safe and not safe? Please advise,