2015年7月20日 · SATA specifies a different power connector than the decades-old four-pin Molex connector used on Parallel ATA (PATA) devices. It is a wafer-type connector, like the SATA data connector, but much wider (15 pins versus seven) to avoid confusion between the two.

2020年8月14日 · I can't find any female-to-female adapters for 7 pin SATA cables. Basically, I am building a Star Trek original series themed workstation, most of it is completed. I'm currently working on a table-top unit similar in design to those seen in the TV show that will be the control panel for the workstation.

2021年1月25日 · You have the regular/classic/original SATA connector. That's 7-pin data, 15-pin power. Micro SATA (Not to be confused with mSATA which is Mini SATA). Micro SATA also known as uSATA is from back in the past, when you had 1.8" drives and some (maybe all), had Micro SATA connectors. But 1.8" drives were rare. It was only on those. The 2.5" drives ...

2024年3月16日 · If you did literally connect a SATA device to a USB host controller, it would not be detected in any way: they differ at the physical layer (SATA runs at 1.5/3.0/6.0 Gbps, while USB2 runs at 480 Mbps; SATA uses 8b/10b while USB2 uses NRZ – although USB3 uses 8b/10b), they differ at the link layer (SATA packet headers have nothing in common ...

All drives with this optional feature will not power up if a legacy SATA connector is used. This is because P3 driven HIGH will prevent the drive from powering up. The easy, and not so elegant, solution is to use a 4-pin Molex to SATA connector or a power supply equipped with SATA connectors that follow the SATA 3.3 specification. Source-Toms ...

2012年7月25日 · From the picture I am not sure if it is pin 1 or pin 7 which broke off, but both are ground. So it actually still might work. (A broken pin 2,3,5 or 6 would have guaranteed that it no longer worked). Not really the "Heck yes, it will still work" you might have hoped for. As to the pins on side: That is a jumper block.

2023年5月1日 · One cable works, the other doesn't. The difference seems to be exact form of the 6-pin connector that plugs into the power supply. The connector on the left is from the cable that works. The right does not. Each of these has slightly different pin shapes, and each has a different no-connect pin.

"3.3 SATA cables and connectors. The SATA interface cable consists of four conductors in two differential pairs, plus three ground connections. The cable size may be 30 to 26 AWG with a maximum length of one meter (39.37 inches). See Table 7 for connector pin definitions. Either end of the SATA signal cable can be attached to the drive or host.

2017年4月28日 · So far, I have attempted to mate these using an adapter that has a 22-pin SFF-8482 on the female side and a pair of standard SATA data and power connectors on the male side. From what I can tell, the only pin difference between the 22-pin SFF-8482 and the 29-pin SFF-8482 is the existence of the additional 7 pins in the middle that form the ...

2017年7月20日 · In this image, on top is a normal sata hdd with its connector, below it is an internal DVD drive with another connector. What is this connector? I'd like to buy a USB -> whatever-this-is adaptor so I can use it as an external DVD drive.