2006年3月31日 · To configure your receiver's impedance setting for speakers with a nominal impedance of 8 ohms and a minimum of 4 ohms, follow these steps: 1. Check Your Receiver’s …

2007年1月20日 · When a speaker is specifies as 4-8 Ohms, it means that the impedance, which is a function of frequency, varies between a nominal 4 Ohms and a nominal 8 Ohms. No …

2008年11月27日 · So, the impedance seen when you separate the LF and the HF and drive them with two separate amps, is the same as if you drove the whole speaker system with one amp. …

2013年1月21日 · With both coils connected in parallel the nominal impedance is 2 ohms and the minimum impedance is one ohm. My amp can handle a 4 ohm nominal speaker, so can …

2009年3月5日 · Also, while a speaker may have a nominal impedance of 8 ohms, the impedance at certain frequencies can drop lower. In a typical no-problems speaker, the actual lowest …

2019年12月10日 · Basically always leave the impedance switching on an AV receiver set to its default 8ohm setting regardless of the rated nominal impedance of the speakers you are …

2018年3月15日 · After reading the 311 page manual, I noticed a section on speaker connection, it referred to speaker impedance and the settings you can alter to account for this. My speakers …

2020年9月12日 · Hi, I own a Onkyo TXNR575E receiver and want to know what speaker impedance setting I should run with it. I have a 5.1 Channel setup with:- 2 front speakers rated …

2005年2月20日 · -Be sure to connect front speakers with a nominal impedance of 8 ohms or higher if you want to select both sets (A+B) of front speakers. In this case, set the …

2007年6月19日 · The Resistive Impedance is 1.51 ohms (QED 79-Strand) or about 19% for an 8 ohm speaker. So at 4,194hz you have a total of 24% loss and at 8,388hz you have a 29% …