Speeduino was born out of a desire to create a completely open, super low cost programmable engine management system without any of the proprietary secrets getting in your way. Speeduino has been in development since 2013 and updates to both hardware and the firmware capabilities are made regularly.

2018年1月16日 · V6 Essex in a 1961 Land Rover.... with Speeduino! If you're deadset on having 6 cyl sequential, it would be possible to run 2 boards, each controlling 3 channels. You'd setup originally on a single board and semi-seq, get the tune right and then move the same table onto another controller.

Speeduino is the leading open source engine management system (EMS / ECU)

The Speeduino project is a flexible, fully featured Engine Management Systems (EMS aka ECU) based on the low cost and open source Arduino platform. It provides the hardware, firmware and software components that make up an engine management …

2024年5月26日 · Speeduino - Arduino based engine management. Contribute to speeduino/speeduino development by creating an account on GitHub.

2022年11月30日 · As our car is a v6, this means that we'll need to run both fuel and ignition in pairs (much like the MegaSquirts). There is an eight channel board (the dropbear) available, but it's often out of stock and so is not covered in this post. You can find documentation, here. Before getting started, you'll need the following: A speeduino.

This manual covers the hardware (sensors, wiring etc), software configuration and tuning elements related to running a Speeduino unit.

For a V6 with a firing order of (1,4,2,5,3,6) the injectors will be wired in 3 groups of (1,5) and (4,3), and (2,6) as these cylenders are 360 crank degrees apart. Inline with the above, this configuration requires each injector output to be connected to 2 injectors.

2021年1月30日 · Speeduino doesn't support edis as it doesn't need it! The 36-1 trigger wheel that edis uses is a good option for speedy and many of the coils when connected via a suitable ignitor are also good units.

What you will get is flexible and configurable fuel and ignition management that will work for the majority of every day type setups. Currently supported features include: Modular wheel decoder support. Included decoders: Taking requests...