2016年1月8日 · The V2.1 drivers are for the mbed enabled version of the ST-LINK I'd start by using the ST-LINK Utilities, make sure you update the firmware, and then use the V2 or V2.1 …

2024年12月5日 · A NUCLEO-F103RB without an ST-LINK/V2-1 (after cutting the ST-LINK part of the board): 2. Pin connections First, we need to power our NUCLEO-F103RB. To do so, we …

2024年1月19日 · Trying to connect to a STM32H723ZGT6 for the first time. Does the ST/LINK-V/2 have to use the JTAG connection on this device as I feel it probably does? The 4 pin …

2016年3月25日 · Introduction The ST-LINK/V2 is an in-circuit debugger/programmer for the STM8 and STM32 microcontroller families. The single wire interface module (SWIM) and JTAG/serial …

2025年3月2日 · 2. When using ST-Link within STM32CubeIDE the next time, a firmware check will indicate the firmware is the wrong version. Proceed with the firmware update. Accept all …

2023年9月15日 · I have an original ST Link V2 from ST on the back is [B 2022 48 ] just purchased 2 days ago from Digi Key ( your trusted supplier/distributor ). I have several bluepills …

2024年11月7日 · Hello The LED on the top link is red. Is it a problem with the connection or the driver? I can't figure it out. Can you help me?

2020年11月26日 · Solved: I am using v 1.5 of STM32CubeIDE, and an ST link v2 running firmware V2J37S7. I have chosen the CPU that I have on my custom board

2019年6月4日 · Check that the ST-LINK can see and report the Target Voltage, pin 1/2 need to see power. Strap BOOT0 high to observe if the part is responsive when executing ROM code.

2024年12月18日 · For flashing and debugging, I want to use the Embedded GDB Server provided by ST, specifically ST-LINK_gdbserver.exe. I prefer not to use OpenOCD because I have …