2013年12月28日 · Just ordered an STK3062-III from www.globalsemi.com in Canada (not received yet). I'm still concerned about true "solder and play" compatibility of the STK3062-III for an original STK3062. I've seen some comments on …

2015年7月10日 · The chip in question is a plain Sanyo STK3062 (not MKII,III, or IV) I understand that the MK II, III and IV versions can be used as replacements but with the addition of some external components. The references I have found so far are quite confusing as to what exactly the differences are and what additional components are required.

2022年9月21日 · The difference between the STK3062 and the STK3042iii is that the 3062 incorporates components for stability that the 3042iii doesn't have. If you look at your LV-90 schematic, with the STK-3042iii, you will see a resistor-capacitor network between pins 3 and 4 (12-13 on the other channel) and a capacitor between pins 4 and 6 (12-10 in the ...

2020年10月18日 · Hi all, I have a question about replacing STK modules with an alternate. Specifically a STK3044 with a STK3042II, STK3062II or STK3082II, or even the original STK3042 series. I see the datasheet have them in the same grouping, but show the STK3044 schematic separately. I have two Marantz...

2020年2月10日 · I get self-adhesive heat sinks for them. Thin ones work very well and fit in tight spots. These STK modules run a long time without them so about any heat sink will be a plus.

2013年4月21日 · Hi there! Someone is offering a little nice Akai AM-U04 for a reasonable price. But one of these modules is fried. So my questions are: 1. how good are these integrated devices for small power? 2. can they be replaced by any other …

2022年10月10日 · just to keep you informed, initially this unit had a STK3062 installed, further investigation in the schematic stated that the original was an STK3042… I came to the conclusion that this was replaced by the previous owner. I have now purchased a new STK3062 and STK3042iii (which I was informed that it’s was the same as STK3042)

2025年2月25日 · The .33 ohm resistors tested good. What value resistors should I tack to pins 1 and 0 to test the stk3062. How will I know if the stk3062 is good (relay click)? Should I even do this or just replace the stk0050II? Is the stk0050 the same as the stk0050II? Hope you dont mind all the questions...

2008年11月29日 · If not there are two possibilities; either a power amp module or a pre-driver module has blown. Up until recently the pre-driver was not available as it was OEM'd by Yamaha from Sanyo. However, there was a post here recently by an AK member who had successfully substituted an STK3062 or STK3082 to replace the pre driver.

2021年2月21日 · I have an issue with an Onkyo M-5000 with stk-4044v in it. I replaced the right channel all good, the left channel is low and when you increase gain the left channel is pulling the voltage down big time and protect come in.