2020年5月24日 · Needs a wire ran to the torch, making a simple gas cooled torch lead setup more complicated. While well built, it could be a bit more industrial. Sensors and connectors might get damaged at busy job sites. No sensitivity adjustment. Included wire is not heat-resistant, and I'm not following the directions by using it without a sleeve.

2020年2月22日 · I was on-line and found the "TIG BUTTON". I've never looked back or use any other control for my Syncrowave. I leave the button just loose enough on my torch handle that I can roll it left to right depending on my need with right hand or left hand. You will also get great service from this company. Dave has treated me more than fair!

2006年6月12日 · You would want a mid length cap for 3-1/2" tungsten and a button cap for shorter and to get into tight places. With a long cap you can use a 7" tungsten without cutting it to make it shorter. I tend to use a mid length most of the time and cut tungstens in half and sharpen both ends right away when I get a new box of ten.

2011年10月30日 · torch mounted on/off switch 10-30-2011, 02:19 PM I was woundering if there was a cheaper way to hook a on/off switch for my sync 200.I can purchase the button for 40 dollars but the complete setup is 160 dollars

2009年6月24日 · CK Worldwide makes a nice torch with a built in hand control. You can choose between north/south slider or one that rotates. I have the CK-20 water cooled one, though I use it with a foot pedal cause I just couldn't operate the finger control without wiggling the torch. Not the torch's fault, my fingers just don't operate that way.

2012年1月5日 · I like the triggers out of a bernard mig gun, a cable and a 20-27 male 14 pin amphenol, otherwise I use a rubber covered button out of a T-dyne plas torch Merely use a 2 wire 20 gage cable and solder pins "A" & "B"

2011年5月21日 · Some TIG machines have a small switch on the torch (in place of a pedal) that turns on the arc using a preset heat on the machine.....what is the specific name for this? Last edited by rahtreelimbs ; 05-22-2011, 04:24 PM .

2017年1月29日 · the welder, particularly with 50 foot torch leads. Of course, anyone that has ever looked at the set up manual for a Syncrowave realizes that. Miller shows grounding everything around that could possible pick up stray currents. The TigButton is covered by a 60 day return policy. If someone gets one and for any reason does not like it, we

2005年2月27日 · Weldcraft makes a Stubby setup for the 17V, looks to be about 1" or so shorter than the standard length. You would need a Stubby collet #10N24S (3/16th), a subby collet body #17CB20, stubby #8 alumina #13N12m & the Stubby gasket #18CG20.

2021年6月19日 · Miller has a thumb switch (RCCS) that has a rotatory dial and there are others that use a simple push button switch, like tig button 6061. I did a course in England through Contour Academy and we welded with a thumb switch that as …