2020年1月25日 · Once the wheels are off the ground, place the jack stands at the spots for the factory jack point. At the rear I lift at the centre of the diff on the bottom of the pumpkin. Then put the jack stands under the axle where you would lift with the factory jack.

2021年3月12日 · Yeah, never really can find a definitive answer to jack points on the Tacoma, whether it for this type of install or even just rotating tires or changing a flat. Wish it were clear cut like on cars that have a little notch on where to put the jack.

2018年10月16日 · You can! Which is handy in certain situations, but when you wanna get both front tires up at once then you need to use the front jack point.

2018年4月23日 · Can someone direct my to a resource on the proper points to apply jacks/jack stands on my truck, 2017 SR5 access cab. And any advice on rotating tires would be appreciated too. Thanks fellow Tacoma bros

2018年2月12日 · Recently got a highlift jack, which is now attached via RCI mounts on the side-bed rails. So, if I need to use the highlift to change a wheel, what are appropriate jack points? I do have All-Pro sliders, but those angle slightly upward and would be wary of jacking from that point. The stock bumpers don't look like inviting jack points. Thoughts?

2018年1月24日 · Jack up the whole front end by placing your floor jack in the center of the cross brace under the engine. You may need a spacer (piece of wood) on top of your jack to get enough travel due to suspension sag. Then put a jack stand on both sides of the cross member.

2008年5月8日 · Tacoma Lift/jack points. Discussion in 'Technical Chat' started by chris4x4, Feb 2, 2012.

2022年7月4日 · Many cars have the rear diff housing designated as the rear jack point, including our trucks. In the case of solid axles, like our rear axles, the axle tubes are also often designated as jack stand points too.

2019年6月11日 · Sketchy bad angle even using ARB's hi-lift jack point due to terrain. I also made some "special tools" to use my bottle jack in a drill because screw hand cranking!

I use a 6 x 6 x 12 piece of oak under the front cross member to lift the front and then put jack stands under the frame perimeter. Then, I use a small piece of 2 x 4 x 4 under the rear U-bolt clamp area to lift one side at a time.