2014年2月16日 · 1. Run the design and stop the machine at where you want to stop for an applique. If you have many places for applique stop, continue to do this. 2. Check the stitch number(s) at stopping position(s) on the machine panel. (remember the stitch number) 3. After the embroidery ends, start Design editing on the machine panel (stitch modification). 4.

2016年1月24日 · Hello Had a tech in to check and still having issue Our tajima tehx c1501 single head, After every cut the machine stops, checked , cleaned the knife behind the bobin and still happens. Running a design right after the knife comes out to cut the thread the machine stops, I hear a buzzing noise an...

2023年2月18日 · The Tajima TEHX-C1501 is a commercial embroidery machine that has a feature allowing the operator to switch to the middle needle position. If you are experiencing difficulty in switching to the middle needle position, there are a few things that you can try. Firstly, make sure that the machine is threaded correctly.

2024年7月28日 · In machine embroidery digitizing software Tajima DG/ML by Pulse, there is a number of pre-installed embroidery thread charts however there are times when you need to create a custom chart with different thread thicknesses and or colors Embroidery Thread Charts and Thread Palettes Embroidery Threa...

2015年3月20日 · Tajima has updated their firmware to allow a user to specify the address of the design spooler. This will allow the embroidery machine to connect with the embroidery design spooler without using multitasking. The attached document from Tajima outlines the process of defining the IP address of the design spooler.

2013年11月26日 · Latest release: Version: 14.1.5.5384. Date: 07-28-2013 CHANGES IN TAJIMA DG/ML BY PULSE VERSION 14.1.5.5384 1 TURNING SEQUIN FILL 2.Corel Draw X6 Support 3. NEW LETTERING FEATURES 4. NEW APPLIQUE FEATURES 5. STITCH GENERATION IMPROVEMENTS 6.USER INTERFACE IMPROVEMENTS 7.EDITING IMPROVEMENTS …

2016年5月12日 · Broadly speaking, the problem is that the picker in the machine cannot be adjusted at all, there are no means of doing it. We have screwed the detail loose and tried even to turn it upside down, but it didn't work. Thus, in the way the machine is assembled now, the clearance between the platform and the tip is 1—1.5 mm!

2014年2月7日 · The attached document contains information on setting up LAN enabled machines. It has been updated for 2009 and includes information for the TEJT2 (Neo 2).

2014年10月23日 · I know I have the capability to wind a bobbin on my embroidery machine so that the top and bottom threads match after sewing the item out. I swear I have seen instructions on here before, but of course, now that I need them I can't find them. The main question is how to embroidery thread the thro...

2018年2月5日 · I have a Tajima TEHX-C1501 embroidery machine. I went to power it up last week and I could hear the fan and motor but no display. I went to check the motherboard and found 2 lithium batteries. One battery read at 2.9 volts and the other only read at 1.5 volts as shown on picture.