2013年8月14日 · I have a PWM circuit that drives a TC4427. The input is 4.7volts, the output from the SG3524 I have used. There is nothing complicated about this circuit. It works. However, that said, I cannot get anymore out of the 4427 than a 5 volt pulse. I am driving the 4427 from a fully charged 12 volt auto battery which is also supplying the SG3524.

2022年5月16日 · Hello everyone, I make this post because I need help to play audio with my Arduino and these components, I've seen this video () and I would like to do the same. My components list : - Arduino Uno - Amplifier (TC4427) - Transductor (TCT40) The main problem is how to reduce the frequency of...

2010年6月29日 · > Hi, > =A0I am using TC4427 to drive the MOSFET.. I am giving the signal of 3MHZ > with the voltage level of 3.3v.. I have 3 volt at Vdd pin and -8v at the > GND pin so my output should be swing between 3v to -8 volt.. i am getting > approximate out but not required one.. and also i am not getting 50% duty > cycle.. so can anybody tell me what ...

2017年10月23日 · Hello, I am trying to make a High Voltage Power pulse generator with Requirements Amp output: 15 A Voltage Output: 100V Rise:

2012年10月4日 · TC4427 - this is a two non inverting buffer. I am not sure what's going on when you used TC4427, sometimes we have to using scope to measure the in/out signal. Like Reply

2018年3月29日 · The TC4427 input is shown connected to 5V but I think it should be connected to the opto collector/R4 junction. And, juts a small point, it is worth the effort to clean up the circuit diagram and have the lines straight, not all over the place like the 0V line is. And the 240V input SHOULD NOT have a ground connected to it.

2019年8月6日 · The two MOSFETS are 12NM50's. I am not married to the idea of using these MOSFETS and can order different ones if they will better suite the application. I would like to drive the gates of the MOSFETS from a TC4427 MOSFET driver, which will be powered using a 7.5W 15VDC power supply, which will supply 15VDC to the VDD pin of the driver. The ...

2020年4月20日 · I need an LTspice model for a low-side non-inverting N-channel MOSFET driver. Power supply 12V, Drive current -a up to 5 amps. Input 5V CMOS compatible. This is not critical because it will only be used in early simulation. Can anybody make a recommendation? My thanks for any help given.

2018年5月15日 · As STM32 voltage is 3.3V, I don't know if that voltage is suitable to drive the gate of the mosfet. So, are there logic level power mosfet? I was also looking into gate drivers as TC4427 and ISO5500 but don't know much about them. What would be the ideal procedure that I should follow to effectively drive that power transistor with PWM from STM32?

2021年11月18日 · Does anyone have LTSPICE models for low-side MOSFET drivers? Especially those from Microchip? I found a few in @Bordodynov ’s selection, but SPICE just runs until a week next Tuesday without producing a result. (A lot of “fill ins”, whatever they may be) Or am I just using them wrongly? Do I...