TNC-Xs USB port works with all major computer operating systems including Windows (all versions after 95, including 64-bit), Mac OS X (as well as Mac OS 8 and 9), and Linux. Uses Advanced Demodulation. TNC-X beats the competition in decoding packets from …

Now with the addition of a sound card interface, the Timewave PK-232/PSK rolls it all into one! The PK-232/PSK brings a new level of performance to the legendary PK-232 with sharp, accurate DSP filters for all its internal data modes and dual transformer isolation for …

Mini-TNC is a PIC88 based TNC which decode aprs packets & route to COM port. Mini-TNC is powered by USB. A CH340G is used as USB to Serial converter to obtain TTL Level TX/RX lines for PIC16F88. CH340G Creates a virtual COM Port. This TNC has Screw Terminals for outside communications, i.e. RX/TX/GROUND/PTT

The Mobilinkd TNC4 builds upon the success of the TNC3, offering improved battery life, high baud rate performance, and a USB-C connector. The TNC4 boasts Bluetooth 4.2 support (dual-mode EDR/LE) iOS Compatible; USB serial port; DCD and TX indicator LEDs; Powerful DSP and modem; High dynamic range ADCs and DACs; Buffered inputs and outputs

TNC-X is a Terminal Node Controller (kit) design based on the Chepponis/Karn KISS protocol. It is implemented using a Microchip PIC 16F628A microcontroller, a CML MX614 Bell 202 (1200 baud AX.25) modem chip, an 8K Ramtron FRAM, a MAX232A level converter chip, and an op-amp which provides active audio filtering for the modem.

The NinoTNC is a USB KISS hardware/firmware TNC which looks like the TNC-PI, but isn’t a HAT. It is powered over USB and can connect to any USB equipped computer which supports a program to operate a KISS TNC.

2025年2月17日 · The N9600A is a USB interfaced multi bitrate USB KISS TNC, supporting modulations suitable for all bands and both FM and SSB. The NinoTNC is designed by Nino KK4HEJ for use in Amateur Radio packet data networks.

AGWPE is a program developed by SV2AGW to allow a variety of packet software programs to interface with a variety of TNC's (including KISS mode TNC's like the TNC-X, as well as BAYCOM, soundcard and others). There are quite a few AGWPE users using TNC-X …

Plug the DLP USB module into your TNC-X. The USB socket where your USB cable attaches should be oriented toward the edge (outside) of the TNC-X PC board. If you have the jumpers set correctly for TNC-X operation (see TNC-X manual) the power LED on TNC-X should light.

The MFJ-1270X TNC-X is a low-cost, low power, self-contained TNC currently deployed in thousands of locations worldwide. This USB TNC derives it power from the USB port of your computer. It also supports a separate serial port. The TNC-X is a KISS mode TNC and works with all software that supports KISS mode.