2002年6月27日 · As you can see if you read his thread, he had a whole slew of problems, and his Phaeton technician replaced his J367 Battery Monitoring Controller with a new one at part number suffix C (software revision 2700) status.

Section A (For vehicles equipped with a J367 control module) Use the following procedure to determine if the discharged battery was caused by the customer: 1. Through ODIS GFF (Figure 1): • Select Test plan (A).

2021年3月11日 · 2018 VW atlas with start stop feature. at red light car stops and doesnt atart back. Needed to boost battery. alternator not chatging battery enough. intetestingly i remove the connector at negative terminal to the battery ckntrol module and the alternator is running 14.7V when I comnect the connector to the battery module voltage srops to 13.2V.

2019年5月9日 · Re: VCDS Faults - Supply Voltage B+ & Control Module for Battery Monitoring (J367) Clear codes and drive. I think these codes come when the battery either dies or in your case is swapped out.

A large majority of modern VW/Audi/Seat/Skoda vehicles require the configuration of replacement batteries. The diagnostic steps vary depending on the actual vehicle configuration. Prerequisites: New VW/Audi Battery Installed Aftermarket batteries may NOT have a valid Part Number, Vendor code or Serial number.

2018年8月22日 · I have an Address 61 fault, 00458 control module for battery monitoring (J367), no signal/communication. Can someone tell me where it is located please...

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW ID.4 you can write to us using the link below, describing your problem in detail, we try to answer all questions. Ask your question on the page - Support!

2021年11月10日 · There's a battery control module J367 (subsystem of gateway) on the negative terminal of the battery. In cars with Start/Stop or recuperative braking it will control the battery charge and manage it. Its said that after replacing the battery one should perform adaptation for the module to proper manage the new battery.

2002年6月27日 · In the meantime, you can see the J367 controller pretty clearly in the battery replacement thread. The clearest picture is the second-to-last, labeled 3D0 915 181 D. If you're wanting to know what version you have, you already have the latest revision D.

2019年5月31日 · It really depends on whether the particular model mk7 has what's called (not-surprisingly) a "battery monitor control module" which the techno-folk like to call "J367". It's easy to know if your car has one of these modules because you will see a lump of stuff attached to the negative battery terminal like this (ignore the yellow gunk - it's ...