2013年9月19日 · On mk4 platform stuff they sometimes get an ABS code which, even if you follow the VAS (vw dealer spec tool) test plan it advises to fit an ABS control unit/motor. All it is is a faulty fuseboard on the battery, 20-30 or so for a new one - fixed!

P3043,012355,19499 etc.J538 Fuel pump control module /fuel pump relay/3Q

2015年8月12日 · I've seen a B5 Passat set a code for the J538 before in the CAN gateway, but the BHW isn't equipped with it. The BHW just has the conventional J17 fuel pump relay. Effectively, it means the CAN Gateway was miscoded, or when coded at the factory it was setup to think that such a module existed.

Fuel Pump Control Module (on systems with J538-Fuel Pump Control Module) Possible Solutions. Check Fuel Pump Check Mechanical Pressure and Volume; Refer to proper workshop manual for correct testing procedures; Check J538-Fuel Pump Control Module; Special Notes. TPI 2017024 has details about checking J538 software version.

Insert fuel pump control unit -J538- into mounting bracket on fuel tank and push it in until it audibly engages. Pull fuel pump control unit -J538- to check if it is secured properly. Checking fuel delivery rate, vehicles with four-wheel drive

Check contacts on connector and on fuel pump control unit -J538- for damage. Check voltage supply between contacts -3- and -4- using multimeter → Current flow diagrams, Electrical fault finding and Fitting locations.

2014年7月29日 · Re-coding cleared that J538 error message. Now my next stop is pressure testing the fuel rail. Intermittently car is hard to start. Today morning it started fine without any trouble. Problem again after the work when I started the car. Thank you for the quick help. Don't forget PSI check valve residual not just PSI..............

2021年4月7日 · T10N/1 is the power supply for the fuel pump. It goes through J538. T10N/2 is the signal wire for the fuel pump control module. T10N/6 is the ground for the fuel pump module. IF It was me I'd be checking that ground at J538 or tracing the wire at T10N/6 to back to the ecm at T94/30 to make sure that wires is good. Normally with these cars fuel ...

2011年11月26日 · VW Passat b5.5,1.9TDI 96kW Aug 5, 2012 #1 Hei. Today I noticed that my engine is shaking too much,connected vag-com and got som codes which ross-tech don't have.I got : 00476 - Control Module for Fuel Pump (J538) in instruments and CAN Gateway. ... (J538) in instruments and CAN Gateway. Address 17: Instruments Labels: 3B0-920-xx5-17.lbl Part No ...

2014年2月19日 · Guide out fuel pump control unit -J538--item 1- towards interior between fuel tank and underbody. Unplug electrical connector and remove fuel pump control unit. Installing Installation is carried out in the reverse order; note the following: Tightening torque → Chapter. „Exploded view - fuel delivery unit/fuel gauge sender“