2024年10月2日 · Solved: I would like to clarify the procedure for replacing VG310. Please let me know if am missing anything from the below procedure. To configure the new gateway's IP address, we must first connect with it via the console port. Once we've gained

2023年4月13日 · The standard VG320 and VG310 models are different from the EM versions, and as of now, there hasn't been an end-of-life announcement for the VG320 and VG310 models without the EM designation. If you've recently deployed VG320 and VG310 units, they should still be supported, but it's always a good idea to check Cisco's official documentation for ...

2019年7月3日 · Hello, Does anyone have a simple step by step document or video link for the initial configuration of a VG310? For some reason the standard Cisco guides confuse me lol All replies rated. Thanks in advance!

2019年3月21日 · Hi I understand that the phones need to be registered in CUCM as and endpoint under Essentials, but does the VG310 require any CUCM licensing or any other licensing? I have a customer that believes this is so but I am doubtful Thanks

2016年2月11日 · Hi, Hope you are doing good. I have a question to ask. Can you configure a Cisco voice gateway for example VG310 to allow only analog phones to communicate with each other and to the PSTN without adding CUCM or CME? Regards, Aristide

2016年6月18日 · I am new to VG310 hardware. I have experience with CME/SIP provider services. I was asked to setup a VG310 to a SIP provider to support faxing. Are there any available configuration examples for this? Is the programming similar to …

2021年6月3日 · Hi folks, I am planing to replace the existing VG224 by using VG310. Can i just disconnect the existing RJ21 cable and plug it to the VG310? the port on the VG224 is the same as VG310's? Thanks in advance, Eric

2016年10月6日 · Hello, we're looking to replace a couple VG224s with some bad analog ports with the newer VG310 platform. I have a couple questions for anyone who has used the VG310 as a replacement for the VG224: 1) when ordering the unit, do you need to also order a PVDM3 module in order to utilize the 24 onboa...

2019年3月17日 · Just wanted to follow up. I installed the VG310 at a client site yesterday. It was pretty seamless. I did a "sho int g0/0" to get the mac address, and added it to CUCM with a SCCP integration. Once adding a couple commands at the interface, and adding the interface to CUCM it came right up. It was much easier than I anticipated, and worked well.

2022年4月28日 · Solved: I have a new VG310 configured using MGCP as the protocol. Half of the FXS ports (ports 0/0/12 through 0/0/23) are configured (loop-start) and registered just fine. However, the first 12 ports (0/0/0 through 0/0/11) are having trouble staying