2021年3月24日 · I wanted to give a 2 month review on our recently purchased PelletPro 90 that we bought from TSC. We live in a 2300 sq ft single story ranch style home in northern CA. We see a dozen or so nights each winter where the temps drop below freezing but for the most part, our winters are pretty mild with typical lows in the mid to upper 30's/low 40's.

2021年10月12日 · Hello, I'm trying to choose between one of these 3 stoves. I was set on the Comfortbilt but now looking at Pelpro because of the price. I've done my research and any of these should be fine for my application - secondary heat source for our main floor, 1200 sqft. We have HVAC and a wood...

2014年4月3日 · I have a Pelpro pellet stove. Went to bed and it was burning fine. Woke up and there was no flame and the stove was still on and blowers were still running. Auger was not spinning. Unhooked auger and tested it with another wire and it turned just fine. Hooked it back up to stove and not...

2012年12月24日 · My fan blades recently broke on my Harman PP38+, I have the replacment part, but have been unable to get the old disc off of the motor. I have removed the set-screw and have been dowsing it in WD40, but the damn thing will not budge. Attached is a photo of the issue. Any suggestions...

2023年11月4日 · Went to start the stove this year and it wouldn’t start. Followed all of the troubleshooting steps, replacing the vacuum switch, igniter and feed motor along the way - still won’t work! If I put pellets in the firepot it lights, burns and blows the air out so it has to be the auger or feed motor...

2024年12月4日 · The ESP runs thru the exhaust pipe portion that is within the stove. If you remove the ashpan, then the plate that is in front of the exhaust fan, about 6-8" into the exhaust pathway itself you can see a pin-type thing that does not quite go all the way across the pathway.

2009年3月23日 · If the "push arm" with the flap that moves the slide plate is not 90° (perpendicular) to the feed body, the slide plate may be binding, preventing it opening all the way. This would probably be evident by noises when the feed motor is on.

2016年2月6日 · Well today I wanted to see what would happen so I let continue as the temperature went into the 70's. 2 hours later it was still dropping pellets, hot air coming from the exhaust outside, room temperature into the 90's.

2024年12月18日 · I’m working on a Martin Industries Unvented Room Heater Model VFIP. This unit runs on propane. The heater has a history of the pilot going out after several days. Cleaning the pilot didn’t fix the issue. I tested the heater valve (SIT 820 millivolt) and pilot assembly and some of the values...

2024年11月1日 · Hello. I'm at the beginning of burning season and trying to make sure my thermometer gauge is correctly calibrated for our Ashford 30. Most of the photos I've seen here are with a different gauge than what I have (mine is about 1 year old). At room temp the needle is below the Inactive zone...