The LilyGo T-Deck development board by default uses esptool_py uploader tool, esp_ota network uploader tool for Over-the-air (OTA) uploads and esptool_py bootloader tool. The bootloader starts at address "0x0". Flash mode and boot mode for LilyGo T-Deck development board by default is dio and qio respectively. The board uses opi PSRAM type.

2022年3月11日 · It’s just saying the BIOS drivers for the device loaded incorrectly before the OS starts, it’s not an issue unless you are trying to boot from the SD card. I get this same error, …

2022年4月22日 · Just sit tight on that bootup screen, when it seems "stuck" it will resume booting in 60 seconds or so. Its annoying, but it's easier to wait the 1 minute instead of ejecting the SD card and reinserting.

2022年3月3日 · On the Steam Deck Discord, it was said this happens on boot if an SDXC card is installed (nalex66 mentions his Lexar Play A2 1TB). Doesn't seem to be problematic otherwise. It looks to just be some sort of error with that particular SD card and the BIOS.

2022年3月3日 · DiscoverUserArea(): Assign new RCA = 0x0 fails with Device Error. So far it doesn’t seem to correlate with anything other than intermittent super long boot times. It …

2022年3月8日 · It stops you from booting off of the SD card as well which is frustrating. I use a Samsung PRO Plus (512GB) and get this error 4 times on boot/restart of the device. It's gone if the sd card is no present. The card was formated by steam deck. Games work fine though. It looks like in this reddit post.

2023年7月24日 · The good ones will still take updated firmware while running normally, but the failed T-Deck will not, as it continually resets the USB connection. With trace enabled in esptool I get the following: esptool.py v4.6.2 Serial port /dev/ttyACM0 Connecting...TRACE +0.000 command op=0x08 data len=36 wait_response=1 timeout=0.100 data ...

T-Deck-Plus has assigned the pins on the Grove interface to the GPS module, so the Grove interface of T-Deck-Plus cannot be used. T-Deck updated TFT_eSPI ST7789 initialization sequence on 20240726. Currently, the changes have …

2022年11月20日 · assign new rca = 0x0 fails with device error, get it when devices tries to boot. anyone know what that could be from? u/cslak, you can click here to search for your question. …

2022年3月11日 · When I turn on the Steam Deck, it says "Discover User Area (): Assign new RCA 0x0 fails with Device Error." four times, both when Windows is installed on the SD card and when it's formatted to work with Steam Deck. I've tried this with 4 different cards at this point, re-imaged SteamOS, tried literally everything and can't get anywhere.