if you have access to ERWIN, please take a look the procedure for steering rack replacement. I' ve seen something on VAG-COM at basic settings , but i need access code for security access of J500, to clear learned values. For older vehicles it was …

2016年4月12日 · J500 no communication - 01309 I believe. Took it to different mechanics, even tried the stealership for diagnosis, and, you guess it, they told me they need to replace steering rack to further diagnose...(what a joke! $2700 to further diagnose?). I tried checking ground connections. The ones I identified seem alright.

2007年8月2日 · The J500 Power steering Control module is obviously not communicating properly on the CAN bus. We did unhook the battery again, and in desperation, even touched the positive and negative cables together for 30 seconds or so. Same behavior and same codes still existed. The fuse to the J500 is good and has power on both sides.

If 01309 is stored in multiple Control Modules and the Steering Aid (#44/J500) does not communicate with the Scan tool, check the Steering Aid Control Module Power Supply. Assuming the Fused Power Supplies (typically 2 fuses are used) are OK, in almost all cases the actual Steering Rack (containing the Control Module) is faulty and needs to be ...

After the Steering Angle Sensor (G85) Calibration is completed, the 44-Steering Assist (J500) module may have DTC C10AC - Steering End Stops Not Learned stored. The steering limit end stops need to be adapted as follows: Start the engine and turn the steering to full right lock and hold it for 5 to 10 seconds.

2012年12月6日 · No ABS light on. I have performed other major work at the same time on the car, I would say unrelated to the steering rack (took advantage of the room offered by the removed subframe): upgraded turbo to GTB1749V from Darkside Development, EGR valve deleted and removed (block plate on turbo), EGR cooler removed, new heater hoses, 3 BAR MAP.

Customer: 2012 Audi A8L D4 3.0tdi. Had an ABS meltdown all lights on. Had an ABS meltdown all lights on. Found loom problem with the ABS speed sensor, and replaced the wheel arch cabling with a kit.

The issue is related to the J500 - Steering Control Module which is part of the electrical rack and pinion bolted on the front subframe. My first recommendation would be to inspect these fuses : Safety Fuse 2 - 110A / Main Fuse Carrier / In luggage compartment on battery /----/ Fuse 1 - 5A / ST1 / Relay and Fuse Panel B / Left end of dash

2010年2月26日 · 01309 - Power Steering Control Module (J500) 004 - No Signal/Communication - Intermittent Freeze Frame: Fault Status: 00100100 Fault Priority: 2 Fault Frequency: 91 Reset counter: 156 Mileage: 138921 km Time Indication: 0 Date: 2010.02.16 Time: 18:50:34 Any pointers as to why there is no communication would be greatly appreciated. Regards Jim

2006 Audi a3 2.0. Power steering not working Is it worth trying to replace the steering column control module