Current Engine/Motor Control Module -J623- software can lead to various fault codes within the vehicle. Improved Engine/Motor Control Module -J623- software as of VIN break 3VWG57BU8KM104615.
Starter motor relay - Audizine
2014年4月17日 · They are connected to various other modules, which all talk via CAN bus, including to the J623 ECU. It's the J623 ECU that invokes the starter by grounding those two control lines to the relays, which then passes 12v to the starter.
I need help with "Engine Control Module (J623) Coding" please
2018年4月23日 · The car is a 2007 Facelift Touareg with a V6 TDI BKS engine. It has no DPF or catylic converter, and the EGR has a blocking plate installed. Isn't this car supposed to have a DPF, EGR and catalytic converter installed from factory? ECUs will not accept changes to the coding for emissions requirements that they meet.
车型 GE《Audi e-tron 行驶策略》 - 知乎
由发 动机控制单元J623来控制这两个驱动装置上的驱动力矩和回收力矩的分配。 为了实现这个目的，发动机控制单元需要从其…
01-21-05 Audi Equipment Technical Service Bulletin
2005年1月21日 · The following DTCs and symptom code combinations are stored in the engine control module (ECM), J623 (address word 0001): DTC P023600 (Charge air pressure sensor, Implausible signal) with symptom code 26363; DTC P060600 (Control module faulty) with symptom code 27740.
2013 Audi Q7 ECM J623 pinout - Ross-Tech Forums
2020年7月30日 · I'm looking for the pinout for the T91/32, T91/33 and T91/34 and also T91/15, T91/16 and T91/17. The six pinouts are for the accelerator pedal. I need to know which pins are the 5 Volt Supply #1, Signal #1, Sensor Ground #1, 5 Volt Supply #2, Signal #2 and Sensor Ground #2. Any help would be appreciated. Thanks. I already have it.
20-23-52 Audi Engine Control System TSB
The following DTC may be stored in the engine control module (ECM), J623 (address word 0001): DTC P044200 - (EVAP Emissions Control System (Small Leak) Detected) with symptom code 11955; DTC P045600 - (EVAP Emissions Control System (Very Small Leak) Leak Detected).
- [PDF]
audi-ECU-J623
Avant de déposer le calculateur du moteur -J623-, enregistrer les valeurs d'adaptation des unités d'injection et relever la masse de cendres. Pour ce faire, utiliser un → Lecteur de diagnostic.
Engine Control Module -J623- Note Some Engine Control Modules (ECMs) are not equipped with a protective housing. The removal and installation of the protective housing depends on the engine and transmission combination. The ECM -1- has a protective housing -2 and 5-.
Code P1602-002 - Power Supply to terminal 30 voltage too low
2016年6月19日 · Code P1602-002 = Power to Terminal 30 voltage too low. The wiring diagram below shows Relay J271 and J623 ECM - on my Audi Q7. Per the manual with the...