This guide will help you install the BLTouch probe on your Creality CR-10 V2 or V3 to enable automatic bed leveling. The step-by-step instructions cover which BLTouch kit to purchase for the CR-10 V2 and V3, how to install it, and how to configure the …

This article explains how to add a BLTouch probe for auto bed leveling on the Creality Ender 3 (and Pro/V2), CR-10 series, and other Creality 3D printers. Includes information on which parts to buy as well as the installation steps.

2022年1月11日 · In the menu under Control/Motion/Probe Z Offset it says "Probe Z offset: -0.325". When I use the "Auto home" function the nozzle is parked 5mm above the print bed and I get this message: If I try to adjust the offset in the menu the probe won't go down far enough to touch a piece of paper, it appears to be out of range since it's parked 5mm ...

2021年7月26日 · I changed My probe margin to 15mm, and changed probe points to 4x4 and re-flashed but the probe still travels past the bed and on a 5x5 grid. It seems like the firmware is not saving correctly. What am doing wrong.

In this instructable I’m gonna show you how I installed a bltouch sensor on my creality CR10 3d printer.

2020年8月11日 · Below shows the general step-by-step installation tutorial of a BL-Touch device: 1. Mounting the Probe: Based on the working principle, the BL-Touch is attached next to the printing nozzle. Make sure to get a tool-head ready to mount the BL-Touch device. What needs attention is the mounting distance.

2023年3月13日 · This one is designed for the ender 3 but should work great in the cr-10 as well https://github.com/kevinakasam/KlackEnder-Probe. 38K subscribers in the CR10 community. This is the SubReddit for the Creality CR-10/CR-10S 3D Printer. Please be …

2021年6月17日 · Creality CR Touch, which is specifically designed for 3D printer Auto bed leveling sensor by CREALITY Company. 【Upgrads advantages】CR Touch is upgraded to a metal probe, which reduces wear and tear and greatly prolongs its service life.

2022年2月2日 · Turn off printer, wait 10 - 20 sec, push probe inside and try again. if this too fails, try to screw in or out the set screw by 45/90/135 degrees (less than 180). My case worked (at lest, partially) by screwing in approximately 90 degrees. Note: If turn on printer with probe in - works 100% of time. If probe out, it may/may not work (not sure why.

2023年11月21日 · # Before printing the PROBE_CALIBRATE command needs to be issued # to run the probe calibration procedure, described at # docs/Probe_Calibrate.md, to find the correct z_offset.