2006年1月23日 · Another port is located behind the distributor, right on top the main block rail (where the intake seals to the block), towards the drivers-side. This is the port used for cars with center console oil guages.

2019年5月29日 · You could put a sensor in one position for a gauge and a switch in the other hole for an oil pressure warning light, if you didn't need it for an electric choke thermostat like Jim said. Click to expand...

2009年5月13日 · You can get a short pipe to screw into the block where the sender goes, then mount a "tee" so that the sending unit sits on the top and your line hookup onto the side...and then run your line up towards the grommet on the firewall for your engine wires and in to your guage.

2012年7月23日 · On the original poster's '88, there is an oil pressure sensor for the gauge - it's located on the driver's side of the block near the oil filter. There's also an oil pressure switch, which is part of the fuel pump circuit; it's located on the …

2003年11月10日 · Revhead- those[circled] are choices for the clutch pivot ball location- the one in the middle is a pressure port for the oil guage or a cooler. Doc is on the money-at rear of upper block behind intake- you can use a short straight pipe threaded into block and into a 45degree fitting to screw sender into[chevy factory cars do it this way]

2008年5月10日 · One place is top/rear of engine behind intake 1/8" pipe thread plug. Another is Left side above oil filter 1/4" plug. Most quality gauges come with hookup lines/fittings. There are a couple of places to use. The most common would be just behind the intake manifold to the left (drivers side)of the distributor. This is 1/8 NPT.

2017年11月10日 · The most common location for the small block TBI OPS is just above the oil filter at the left rear lower corner of the engine block. The device next to the distributor (pictured below) is the fuel pump oil pressure switch with orange and tan/white stripe wires attached through a brown connector.

2012年7月28日 · GM INSTALLATIONS: The correct location on most GM V8-engines to install the oil pressure sender is under the distributor housing at the rear of the block. Use the 2 piece bushing kit provided to allow the sender to be mounted at a …

2009年10月6日 · Temp sender is right next to your thermostat housing on the intake manifold and the oil pressure line is in the rear of the block right next to the distributor.

2008年8月12日 · Where is the oil pressure sending unit (-switch) located on the 8.1 vortec engine? I was looking at it and i think that its right by the oil filter location but it only has one wire. The one that i saw on the internet has a three wire connector so that doesnt work.