2015年6月4日 · Be sure to consult your owner's manual or the diagrams on the underside of the fuse box lids for exact fuse locations. The Figures below are a few common fuse box diagrams, and what each fuse controls: Figure 8. Underhood Silverado fuse box diagram. Figure 9. Fuse Block of underhood fuse box. Figure 10. Junction Block of underhood fuse box ...

2016年11月3日 · Cut the truck off, and it started up fine, no codes. Then a few minutes later, went to start it, would not turn over. Symptom we had before (and after a few times) since the unde rhood fuse box was replaced. Nothing I did would let the truck start - UNTIL I unseated the under hood fuse box, reseated it and the truck started right up.

2015年6月8日 · Step 6 – Removed the curved bracket behind the under hood fuse box. This bracket is held in place by four bolts. Figure 6. The curved bracket is located at the driver's side rear corner of the engine bay. Step 7 – Remove the lower engine bay fuse box cover. The lower portion of the fuse box cover simply lifts up and away from the fuse box ...

2011年2月2日 · Currently the truck is running much better and hasn't gone back into the limp mode, stuck in 2nd gear, high reving , yada, yada. Before this I would pull off the road and reset my ignition key. My truck's PCM was before the year end fix in 1996 with the corrected PCM from GM as indicated by the numbered sticker.

2012年6月7日 · 2007 - 2013 (GMT900) - 2008 silverado 1500 big problems. - Hi, I have an 08 I purchased dec of 08, had 29000 miles on it, I have only put 6000 miles on it since I bought it and the last two months I have been having the strangest things happen, been to the dealer 3 times with no luck, hoping someone here may have had...

2015年6月23日 · Find the three HVAC fuses; Two are under the hood and one is in the cab fuse box. Turn the AC and heater switches to the off position, and turn the temperature controls to the coldest setting. Set the HVAC to automatic. Plug in the fuses. Start the engine and let it run for five minutes. The HVAC should readjust automatically. Figure 1.

2015年6月5日 · Installing them should be as easy as removing the door panel, cutting a hole, and plugging the switches in. Install the fuse for the heaters in the fuse panel, and all you need to do is get the BCM re-flashed. Figure 2. Seat heater switches. Step 3 – Take truck for BCM re-flash. The BCM ultimately controls the heated seats.

2009年4月27日 · 2. Second, pull the airbag fuse. This fuse is located in the drivers side end panel, between the door and the dash. On my '95 it was fuse #10 (2-1), it maybe different in your vehicle, so check the chart on the inside of the fuse cover to make sure you have the right one.

2015年6月30日 · Another common problem will be the blower motor will stick in the ON position and never shut off. You can access the resistor module behind the fuse box located on the driver's side lower dash compartment. You must visually inspect the resistor, and make sure it isn't melted or burnt. If it is, then replace it.

2015年6月3日 · Look for the 175-amp mega fuse in your engine compartment. Make sure that it's firmly seated, and that the fuse is still good. If the mega fuse isn't the problem, then check the connections going to the fuse box. You can also try removing and reinserting the fuse box. Sometimes, one of the connections is loose and needs to be re-seated. Figure ...