2013年4月9日 · Re: Opinion: Use A/C Coil Cleaner on the logs or not? Pics attached I have been doing a lot of toon cleaning this past week. IMO, coil cleaner or 75%/25% muratic acid/water worked the best. Spray it on, give it a few mins, power wash it all off. That was the cleaning part. Then I followed up with a gallon of the NAPA Aluminum Brightner.

2009年9月3日 · It will also discolor your trailer. Even though some of the pontoon cleaners have acid in them, do not try to use muriatic acid. Coil cleaner, however, works well. It is a non-acid, base product. It will still burn you. You can mix the strength to suit your needs depending on how oxidized your logs are.

2012年3月1日 · The plugs I was running were recommended in the own man. He informed me that I had a Z missing in the part number and by adding this Z you got an inductor resistor (coil of wire, not a purely resistive element as in a conventional resistor plug) in the plug which helped, especially at cold temps to get the plugs firing correctly.

2025年3月7日 · Back Electrical. View All; Boat Wiring & Cable ...

2009年12月7日 · I haven't tackled cleaning the toons yet, and there are many suggestions as to what to use. If you use the "search" feature at the top, you can recall those threads and posts. I'm probably going to try air conditioner coil cleaner, as suggested in a couple of responses. I …

2011年5月19日 · Warning: Do not put a lot of pressure with your fingers on the top (where the brass screw threads are) and bottom of the ignition coil. You may snap the fragile Ferrite core inside. 1. Gently peel back the rubber protector and take it off of the ignition coil. 2. Check to see if there are any noticeable cracks. If so, replace the coil. 3.

2008年6月19日 · The charge coil is the power source for the power pack and the power pack is the "load" for the charge coil. The charge coils are pretty much a lengthy piece of continuous varnish coated copper wire wrapped around an iron core. Resistance can give you a reasonable test of the coil's status.

2010年1月14日 · the F115 WONT stall at pulser coil failure. actually it may or may not stall at initial failure but will restart. keep hunting. if a pulser coil fails on the F115 it locks ign timing at 10 degrees BTDC,idle speed goes to about 1000 RPM,fuel is fixed and top speed cannot be reached and both ign coils are controlled by the ECU and all 4 plugs spark.

2013年11月14日 · The Points and Condenser or Ignitor I installations require a coil with 3.0 ohms of internal resistance or you need to have either an external resistor or resistance wire upstream of the coil. If you have a resistor the Ignitor red wire hooks to the wire feeding the resistor and the black wire hooks to the (-) side of the coil.

2013年6月29日 · Good morning folks. I am trying to figure out a voltage problem with my coil. Motor is a 1983 3.7/470. I was reading the resistance to the coil I have twins. The good motor is within spec, 1 to 2 ohms. The bad one is 4 ohms. I have the 1 wire alternator. The resistance wire kit is 84-94227A2.