2013年8月8日 · The DiSEqC types are not interchangeable and each type issues a unique DiSEqC command that will only control a device of the same DiSEqC type and command line. The ability to edit the DiSEqC 1.2 position assignment makes no difference if the STB can be used for DiSEqC 1.2 switch control.

DiSEqC 1.2 OPERATION . The Motor is designed for DiSEqC 1.2 Receiver. The commands on the receivers might be different, but similar. Please refer to the manual of the receiver. 1. Go East / West: Drive the dish to East / West. 2. Fine Tune East / West: Drive the dish East / West for one step. 3. Store nn: Store Satellites Position nn (01~60). 4.

2008年6月9日 · 5. DiSEqC 1.2 drives H-H antenna motors so that all of your favorite satellites can be received. It has some weaknesses with regards to storing satellite positions. 6. DiSEqC 1.3 also drives H-H motors. With the position calculations built into the receiver, it takes full advantage of the DiSEqC 1.2 GoTo X commands.

2011年9月6日 · To feed four satellites to two receivers you would either need four bandstacked LNBFs and a 4x2 DiSEqC switch or four dual output LNBFs and a 8x2 Multi-switch. As Anole pointed out, the two output switched would be hard to find, so a four or eight output might be more readily available and less expensive.

2017年7月10日 · An 8 port DiSEqC switch is type 1.1 or 2.1 (DiSEqC 1.0/2.0) only controls up to 4 port. On each satellite that you wish to activate in the receiver list, disable 22KHz, disable DiSEqC 1.0, enable DiSEqC 1.1 and select the correct port for the required LNB.

2016年6月23日 · Over the last few weeks I have been working on a DiSEqC decoder using an Arduino board. The idea started a few years ago when Mike Berg, N0QBH posted his...

2016年3月20日 · Diseqc 1.0 is therefore compatible with 13/18volt switching; 0/22kHz switching; and toneburst switching. (For switching on option-command, there is no other (older) way of switching than via the diseqc protocol.) The LNB-switching between band and polarization is very very rarely done with diseqc though, I believe.

2010年5月23日 · Diseqc command 6F goto +/- x.x° tells the motor to move that man deg +/- off of 0° so use 6F to tell it to move to 0° is that what you mean ? or do you mean to erase all the stored positions in the motor's memory ? if so use 6F to goto 0° then run through all the stored memories one by one all saving their position.

2007年2月5日 · A typical result will be that I set the receiver to deliver power on diseqc #4 and discover these voltages at the ports: #1 - 0.03, #2 - 0.06, #3 - 13.84 and #4 - 13.84, and all this on a switch that from other experiments appeared to be working ok!

DiSEqC 1.2 DiSEqC 1.0 No DiSEqC Remote Control Note Control. Pos Ions No Yes I Optional No Yes I Optional Yes / Necessary Power OLIOff 60 60 60 60 vin Full controlled receiver. Controlled by receiver or o tional remote control. Controlled receiver, Controlled by receiver or optional remote control. Just like ±nd-alone positioner. RESET Sat No ...