2004年9月20日 · try doing a "ifconfig eth0 down" to take the network card down , athen find the exact module for the eth0 in your modules.conf or modprobe.conf file and unload the module …

2005年11月27日 · Running Debian Unstable. Recently when booting I sometimes get the message: eth0: link down and then the PC cannot connect to the network. There are 5 DHCP …

2011年2月21日 · I'm having a real problem with ifconfig， first： i added a ipv6 address to eth2 of my host，and the result show it‘s work， second：i used the command ifconfig eth2 down to …

2005年7月7日 · Get a virtual cloud desktop with the Linux distro that you want in less than five minutes with Shells! With over 10 pre-installed distros to choose from, the worry-free …

2006年5月29日 · On Redhat WS 4.0 I'm having a real problem with both eth0 and eth1. ifconfig eth0 down and ifconfig eth1 down do not work. Code: # uname -a Linux entropy 2.6.9 …

2005年12月21日 · Welcome to LinuxQuestions.org, a friendly and active Linux Community. You are currently viewing LQ as a guest. By joining our community you will have the ability to post …

2023年7月21日 · If the interface is detected and in the list as eth0, then the interface is detected, and is probably just in a down state, which can be easily remedied with this command: Code: …

second：i used the command ifconfig eth2 down to make the eth2 down,and up again. third: i used the ip addr command to show the ip information,and found that the ipv6 address lost. the …

2007年8月31日 · which had three devices (eth + grfx + IDE cont.) on IRQ 20. After struggling with all types of ACPI kernel parameters to no avail, I had to switch PCI slots of the graphics card …

2007年3月24日 · eth0 is down. I booted up in Damn Vulnerable Linux, and for some reason even though it said dhcp was ...