If after performing Guided Fault Finding (GFF) for fault code P2014 in the ECM, the Intake Manifold Runner Position Sensor -G336- requires replacement, only replace the sensor, NOT …

Check Intake Manifold Runner Position Sensor 1 (G336) and wiring, see repair manual. Some vehicles may have a vacuum solenoid valve (N335 or V63) located under the air filter housing. …

2015年4月13日 · As one of my previous posts mentioned, I'm going to be changing one of intake runner sensors G336 (potentiometer) ; upper and lower actuators are functioning ok per …

2018年5月18日 · If the fuel rail is removed or replaced, the intake manifold runner position sensor -G336- must be adapted to the Engine Control Module (ECM) -J623- . Use a vehicle diagnosis …

Inspect, test and replace leaky vacuum line. Inspect Intake Manifold Runner Position Sensor 1 (G336) and test wiring. Possible Causes / SolutionsPossible Causes: Vacuum leak Faulty …

17506/P1098/004248 - Intake Manifold Tuning Valve Position Sensor (G336): Open or Short to Plus Possible Causes. Intake Manifold Runner Control Basic Setting not performed; Wiring …

2020年11月25日 · The fault code above could be due to an intake manifold/flap concern that is allowing the G336- Intake Manifold Tuning Valve Position Sensor to move past it's normal …

2021年6月27日 · So far in my research Audi does not list separate from intake manifold, but does make reference to as switch G336. This switch has been mentioned several times in different …

Faulty Intake Manifold Runner Position Sensor1 (G336) Intake Manifold Runner binding or sticking; Possible Solutions. Replaced failed vacuum line; Check Intake Manifold Runner …

2022年12月29日 · Here is the wiring diagram for the intake manifold G336 and V157 composing the electronics on the intake manifold itself. J623 is the ECU itself with T60 being one of the fat …