2014年12月18日 · 03182 - Clutch Position Snesor (G476) Short to Ground. I have replaced the G476 sensor (which is intergrated into the Master Cylinder) and the fault is still there. Does anyone have any information on this?

2018年4月8日 · You have to split the transmission from the engine, the sensor (G476) is mounted on a bracket (1 bolt) which is located by 2 dowel pins. A special tool is recommended for removing the sensor bracket T10055. The sensor is $210 U.K. price.

If the clutch pedal still cannot be moved further, or if the message in the instrument cluster does not go out, check the operation of the Clutch Position Sensor -G476-. Close the bleeder screw on the clutch slave cylinder. This TSB is informational only and not applicable to any Audi warranty.

2021年6月7日 · The clutch position sensor (G476) is a Hall sensor that sends a signal to the ECU when it senses the clutch pedal depressed via a magnet affixed to the clutch master cylinder piston coming into close proximity of the sensor itself. The G476 sensor has 4 wires going to it, a "power supply" wire, a ground, and two ECU signal wires.

2016年5月25日 · I need help with the EPB on a Q3 Error G476 Open or plus DTC The vehicle starts so the clutch switch is working. If i check clutch position with mass blocks it stays on 255.

2014年12月18日 · there is the G476 Clutch position sender which from my understanding measures how worn the clutch is by the amount of fluid passing through the master. If anyone has further info on the G476 and how it operates, i would like to know as that is the problem my car has. You can use a Vagcom to measure the blocks of both the switches.

2021年11月24日 · After 1 week the error with starting the car came back, I have also had problems with a TPMS malfunction, and the cruise controll is not working. I ran a new scan and from these error messages I guess I need to change the clutch master cylinder, since that is where the sensors for the clutch is. Anyone else have any input here?

2023年6月3日 · Need to find a new erwin.audi.com solution to get proper full world wiring diagrams. Luckily, it seems the old 8T copy I have is a full world version. Because searching the more recent 8T document from audiusa came up with nothing about green/gray on T94/63, because all the TDI sections were deleted.

2014年6月6日 · 2008 Audi A5 1.8 TFSI 03182- Clutch Position Sensor (G476) fault code. Where is this switch located on B8? I can not see it inside car/clutch pedal where...

2016年10月25日 · I noticed something extremely strange - the fault code shows a problem with F36 Clutch Pedal Switch. Looking at ELSA my car does not have such thing Clutch pedal sensor on my car is the G476 hall effect sensor that clips onto the master cylinder in engine bay. F36 is a switch which is installed just above the clutch pedal inside the cabin.