2005年2月11日 · The diagrams for both the "8T2" 38-pin ABS module currently in my car and the new "8T3" 46-pin retrofit part list a set of three wires going to "T3di connector" going to "G608", which lists as the "Vacuum Sensor".

The vacuum sender -G608- is only installed in selected petrol engines. Open clamp -2- and screw-type clip -3-. Remove air ducting hose -1-. Disconnect connector -3- from vacuum sender -G608--1-. Unclip vacuum sender -G608--1- from vacuum line -2-. Make sure to check the seal for damage before installing the vacuum sender -G608-.

2017年7月14日 · G608 sensor, fitted to the brake booster, 3 wires in a T4 connector housing. T4aj/1, brown/white goes to ABS T38a/21; T4aj/2, not used; T4aj/3, brown/red goes to ABS T38a/20; T4aj/4, brown/green goes to ABS T38a/8; Verify those wires are to factory design. If so, then I would suggest a new sensor as the next step.

Remove the vacuum hose with the Vacuum Sensor -G608- from the brake booster. Release the clips using pliers -1-. Carefully pry down the Vacuum Sensor -G608--2-.

Removing and installing vacuum sender -G608 Note The vacuum sender -G608- is only installed in selected petrol engines. Removing ...

Remove the engine cover. Disconnect the vacuum hose together with the vacuum sensor "G608" from the brake booster. Unlock the clamp with pliers "1". Carefully pry and remove the vacuum sensor "G608" "2".

View and Download Volkswagen Touareg 2010 workshop manual online. Touareg 2010 automobile pdf manual download.

2003年1月12日 · The following fault code may be stored in the Brake Electronics Fault Memory: 03366 - Brake electronics - (03366) Vacuum Sensor -G608 Implausible Signal. This condition occurs due to an incorrect sampling rate between the ECM and the G608 Vacuum Sensor. The symptom as described will store the fault 03366 in the Brake Electronics Fault Memory.

Volkswagen Touran Reparaturanleitung / Bremsanlagen / Bremse - Hydraulik, Regler, Versträter / Bremskraftverstärker/Hauptbremszylinder / Unterdruckgeber -G608- aus- und einbauen

2019年7月30日 · Trennen Sie die Steckverbindung -3- vom Unterdruckgeber -G608--1-. Prüfen Sie vor dem Einbau des Unterdruckgebers -G608- unbedingt die Dichtung auf Beschädigung. Bei beschädigter Dichtung muss der Unterdruckgeber erneuert werden.