Our factory has perfected the manufacturing process for SuperSleeve™ LC200 High Density Polyethylene (HDPE) Pile Sleeves, achieving a thickness of 0.200″. These sleeves are designed to fit almost any consistent size OD pile—whether steel, fiberglass, wood, vinyl, or concrete—with approximately +1/16” clearance, unless more clearance ...

HDPE pipe products including, repair clamps, couplings, tapping sleeves, service saddles, restraint and pipe end stiffeners.

Used to create circular sleeved holes in concrete poured barriers including walls, floors, ceilings, structural supports and tank footings. Molded from non-conductive, high-impact resistant HDPE, these sleeves are lightweight and easily installed by one construction worker.

The GF pipe sleeves secures pipes without scratching during expansion and/or contraction and allow for free movement. They are ofered in two lengths and multiple diameters and can be used with a variety of clamps.

Infinity® wall sleeves are designed for concrete poured barriers to construct a circular penetration through walls, floors and ceilings. Infinity® are lightweight for an easy one-man installation. …

High-density polyethylene (HDPE) corrugated sleeves are used in hot and cold potable-water distribution systems, primarily in commercial applications where the potable tubing is installed in the slab.

Infinity® wall sleeves are designed for concrete poured barriers to construct a circular penetration through walls, floors and ceilings. Infinity® HDPE wall sleeves are lightweight for an easy one-man installation. The Infinity® wall sleeve is available in 16 sizes ranging from 2”– 25” in diameter and can accommodate wall thickness up to 16”.

Custom sized sleeves are our specialty. If you have an odd-sized pot or an oddly shaped plant, we can work with you to get your sleeve just right. All sizes are in inches and measure Bottom x Top Opening x Height. These sleeves will fit the indicated pots. All HDPE sleeves are on woodheaders and have vent holes.

Our SuperSleeve™ HDPE Pile Sleeves LC200 (.200″ thick) are designed to fit steel, fiberglass, or concrete piles measuring 12” or greater in diameter. Manufactured in Houston, TX, the sleeves are pre-fabricated, easy to install, and equipped with fuse-welded caps to …

2020年7月21日 · Now Available – The LC120 & LC200 HDPE Pile Sleeves “Fuse Welded” to the PE Top Caps, (Flat or Cone Type) at our factory. This eliminates attachment steel hardware, which will rust over time, thus caps will fall off. Shipped for …