In order to utilize both paths from the Mlutilayer Switch network to the R3 networkS, you can configure Multigroup HSRP (MHSRP) between R1 and R2. Essentially, R1 is configured with …

Firstly, I know HSRP is a layer 2 configuration. In previous labs (and real life setups). I have always configured 2 collapsed cores/distribution switches to share a layer 2 Port channel, and …

Here's a thread I've started on gns3 site about an issue I had with HSRP on switches emulated within GNS3 with some 12.4 IOS:

Files(1) Show actions for Files Drop Files Upload FilesOr drop files STP_EtherChannel_HSRP.pkt.zip Zip STP_EtherChannel_HSRP.pkt.zip Dec 2, 2020 11KB …

I've done most parts of the lab but got stuck at HSRP for some reason. Basically, on R3 & R4 there are sub interfaces f0/0.10 & f0/0.20 on R3 corresponding to Vlan 10 & 20, and f0/1.10 & …

When two HSRP routers come up, they will send (i suppose, per the poor labs I tried to create yesterday) first a gratuitous ARP reply for the IP address configured on the interface and then …

2023年5月10日 · By default, HSRP uses a 3-second hello timer, while VRRP uses a 1-second advertisement interval. Notice the terminology here is slightly different. Both are tunable, so …

Cisco ASA configured as Active/ Standby: ASA01 is Primary, ASA01 is Secondary. G0/1 on CoreSW01 and CoreSW02 is configured as access vlan 10. EtherChannel connects …

There is no learning states in HSRP, just those 5. The mac address is not taken into account to define the active router, but apart the priority and the higher ip, also the first router that came …

I believe "SHOW STANDBY" will show the hsrp version number if not version 1.