2013年6月27日 · If you have used parts check out king pin bushings, tie rod ends. steering linkage. then alignment, Castor, camber, toe, I bought a 37 ford dropped axle for $ 25, It wasn't right, and later found the car had slid sideways into a tree. WE had a 50 ton press at work and were able to fix it in about 30 minutes.

2011年11月13日 · I don't know what type steering your going to run but on a Chevy the drag link needs to be as level as possible in order to avoid bump steer. Edit: I'm running 3 degrees caster on my dropped axle, pretty close to factory spec (again for a Chevy). Hope that helps.

Secret is an exclusive new independent front suspension that uses forged I-beam front axles borrowed from big-truck design. And Ford uses not one but two axles. Result of this new kind of font end: untrucklike riding smoothness – better steering control – slower tire wear – lower maintenance and repair costs.

Bottom line: if you're swapping on later model hardware, it's best to swap the I-beam and spindle as a unit. If you MUST mix and match, follow these simple guidelines: If you're using '67 I-beams, use '73-'74 spindles and kingpins. However, the round pin used for the bump stop in the '67 I-beam may need to be trimmed or modified, as needed.

2016年12月14日 · This will work for just about any styrene I-beam or tubular front axle you may wish to convert to pose-able steering...for hot-rods, gassers, trucks, antique and classic cars, etc. The work shown here is a little on the Q&D side, but take your time, work carefully, and it …

Inspect the axle to ensure proper assembly and to identify broken parts and loose fasteners each time the vehicle is lubricated. Make sure spring to axle beam mounting nuts and steering connection fasteners are secure. Wheel Alignment - Follow vehicle manufacturer’s instructions for wheel alignment inspection intervals.

Giant Motorsports has specialized in I beam suspension kits for years, and is now proud to offer the newest kit, “The Ranger/Explorer 4WD Dana 44 TTB conversion kit”. This kit is designed to convert your 86-97 4WD Ranger/Explorer (with stock Dana 28/35 beams and spindles) to the bigger Dana 44 TTB setup, utilizing the stock …

2013年9月8日 · I recently had to have the front end aligned by a Ford shop to correct a off center steering wheel and a significant pull to the right. Wonder if this realignment may be the cause? Before the camber was 1.0 and .5, caster 4.6 and 3.1, with toe at -.41 and -.47. total toe at -.88

Squeeg’s 14" Aluminum I beam steering wheels. Available in natural cast finish or polished. Unwrapped so you can have it wrapped to match your upholstery.

2009年11月17日 · I am looking at my set-up on the computer and it appears to me that a swing-set style set-up will only work for a vehicle that has rear steer knuckles. Is this correct? When the drag link puts input into the swinger box then the output …