2008年2月24日 · I know a lot of you guys have this error 17967 in vag com and it won’t clear and when you try to do a throttle body alignment it errors, so if you have this problem read on! Step1 remove the 4 Allen studs that hold the throttle body on the intake manifold you will need to remove the vac pipe and induction pipe to.

2023年12月11日 · Reset Throttle Valve Control Module (J338) To Reset the Throttle Valve Control Module (J338) learned Values save '0001' as new Value and cycle the Ignition OFF/ON to ensure the Values are Reset properly. Make sure to perform the Throttle Valve Control Module Adaptation after Resetting the learned Values!

2006年2月6日 · I've been trying to cure the idle "stumble" so I tried cleaning the TB. I only took off the hose and sprayed the TB...

2015年5月18日 · Hi I am getting this code 001592 with P0638 on my 2009 Jetta TDI. I took the throttle body off and cleaned it. Could not remove the cover there was restriction and I did not want to break it. After putting it back together I tried to calibrate the throttle body with the system, but I am not sure if it is working.

2023年5月4日 · I have a scan with the Code 001592 for the Throttle Body Actuator Bank 1. I look on the web and it seems that I need to clean this actuator. After 11 years, is it a good idea to clean it or change it ? Thanks for the help. 09-Cent. Elect. -- Status: Malfunction 0010. 52-Door Elect, Pass. -- Status: OK 0000. Bin. Bits: 00000000. Bin. Bits: 00000000.

2008年9月12日 · I've had the snow kit for over a year, and I recently had to replace, out of my own pocket, my entire throttle body. I believe the failure was caused by too large of a nozzle being used. I was throwing cel's and epc's and going into extreme limp modes.

17972/P1564/005476 - Throttle Actuator (J338): Under-Voltage during Basic Setting Possible Symptoms Throttle Body Alignment (TBA) unsuccessful Possible Causes Battery Voltage too Low Possible Solutions Check Battery Voltage Connect Battery Charger for …

2022年11月9日 · -- Using a multimeter, measure the voltage between terminal 1 and 3 of the Throttle Valve Control Module -J338- electrical harness connector. Specified Value: 3.47 V (+/- 1 V)

2009年7月13日 · The document provides instructions for checking the throttle valve control module J338. It describes the components of the throttle valve control module and outlines a test procedure to check throttle valve position at idle and wide open throttle using a scan tool.

2024年8月11日 · 针对大众轿车发动机节气门控制组件 J338，重点介绍了工作原理、数据检测与 分析以及基本设定方法，对相关故障的排除具有一定的指导作用。