2016年2月19日 · Hello. I have the EPB J540 module replaced and now I am going to test the car. All DTCs cleared so that I can check if anything shows up again. Anyway, the fault was diagnosed by two people as being the module - at least that was related to firmware version that my model could be affected - for the good or bad, the module I have installed is ...

2021年8月24日 · J540 is the control module for the electronic parking brake. It's at address 0x53 on the CAN bus. Look for address 53 in the module list in your OBDeleven.

2023年10月1日 · 00473 - Electric Parking/Hand Brake Control Module (J540) - No signal/communication I checked motor connections and pins. Tested all fuses, inspected park brake module plug and everything looks good.

2019年10月25日 · 00473 Control Module for Electric Park- / Hand Brake (J540) the car shop is telling me to take to the audi dealership to see if they can program it. i need help b/c im lost at this point!

你好，根据故障现象描述和故障码分析，该故障原因为驻车制动模块内部的水平高度传感器位置错误，需要检查驻车制动模块的安装位置，以及安装平面是否存在水平位置，通过检查调整后，再次测试故障现象。 08年奥迪A6，老是报驻车制动器故障。 然后只要，仪表上面驻车制动器一闪灯喇叭都没反应。 您好，建议您读取53。 地址码。 驻车制动控制系统。 内部是否有故障？ 如果有故障全部清除掉。 清除故障后再测试系统是否正常，如果系统正常请检查，手刹电机插头线束 …

2025年1月17日 · 仪表显示屏报驻车故障，用5054a看了一下是模块j540故障，图2这玩意，还有之前j393模块坏了，人家远程帮我编码过了，结果现在全部雷达没用了，就一个倒车影像有显示，就这样吧，过年后再折腾吧……

2019年8月12日 · The right parking brake motor, V283, is a simple two wire connection to the J540 parking brake control module (your address 53 device). The J540 apparently sits at the bottom of the control boxes in the back right area of the trunk/hatch. It has a single 30 pin connector.

2019年4月3日 · When you get a variety of system warnings all at once and out of the blue, it's usually the best place to start looking and rule out. Check your brake fluid levels. I've seen something similar happen in the past.

2015年6月9日 · Park/Hand Brake (J540) The car is a 2005 Audi A6. The parking brake will work while driving and I can hear the motors on both sides working when I turn the key from the off position to the accessory position and back, but the parking brake switch will not let me either engage or disengage the parking brake while I am parked.

00473 - Control Module for Elect. Park/Hand Brake (J540): No Signal/Communication Possible Causes. Wiring/Connector(s) from/to Control Module for Elect. Park/Hand Brake (J540) faulty; Fault(s) stored in Control Module for Elect. Park/Hand Brake (J540) Possible Solutions. Check Wiring/Connector(s) from/to Control Module for Elect. Park/Hand ...