2022年1月13日 · "The jumper JP6, labeled IDD, is used to measure the STM32 microcontroller, the level shifter and the SMPS consumptions (depending on solder-bridge configuration), by …

The STM32 Nucleo-144 board and shield can be powered from the ST-LINK USB connector CN1 (U5V), by placing a jumper between the pins 3 and 4 of JP6, as shown in Table 7: Power …

2024年10月23日 · The easy way to do this is to create an MX project based on the Board or MCU, go to the Clock Configuration and select a SYSCLK on the range where the power scale …

2017年3月1日 · With JP6 you probably expect the CPU not to work. However any voltage on a pin not 5-Volt tolerant with supply VCC to the target CPU by the pin protection diodes. Both …

The STM32 Nucleo-64 boards, based on the MB2046 reference board (NUCLEO-C071RB and NUCLEO-C092RC order codes) provide an affordable and flexible way for users to test new …

2024年11月21日 · Connect the ammeter in series between the two pins of JP6. This allows you to measure the current flowing directly into the MCU’s VDD line, which represents the power …

5 Volt is the default power supply, provided by the host computer through the USB cable. The reset input of the ST-Link is by default disconnected (JP6 OFF). Note that the ST Link-V3 …

2019年5月29日 · I want to measure the current consumption of the uC on my STM32 Nucleo-64 evaluation board (NUCLEO-L073RZ). The manual says, that I just have to remove the …

Jumper JP6, labeled IDD, is used to measure the STM32 microcontroller consumption by removing the jumper and by connecting an ammeter. Jumper ON: STM32 microcontroller is …

2018年2月26日 · I'm measuring the current on JP6 (IDD) and I see 4mA at the lowest when running the Power_Management sample or even holding the MCU in reset. I am powering the …