2022年2月18日 · I was continuing to get C2200 even after all the CELs and ABS was cleared with the JSCAN. Everything online and apparently in the manual tells you the fix is a new or rebuilt ABS module. I kept clearing the codes and realized the JSCAN allows you to go into the ABS module and select all the valves, etc and open/close them. While parked.

2014年2月28日 · ABS and traction control are tied into the same system in modern vehicles, so maybe there is a low brake fluid level that is triggering all three lights. 1993 Wrangler S 2.5L/AX-5/NP231 with SYE, Spartan locked Dana 30/Aussie locked Ford 8.8 @ 4.88, SOA lift with 2.5" OME HD springs and front Bilstein/rear Rancho shocks, Barricade 9500 winch ...

2012年1月20日 · I have a 2007 JK I extended the brake lines but I think I still need to extend ABS sensors. Any help/advice would be appreciated BDS 4 1/2" Lift 1" DayStar Body lift, 1 3/4" Rusty's Offroad Front & Rear Adjustable Trac Bar

2024年3月17日 · In researching my ABS module issue I recently have noticed the brake fluid leaking out from under the cap. Dealer wanted $35 for a new cap. Auto Zone had one in stock for well under $20. Since replacing the cap my issue hasn't completely gone away as I wait for a new ABS Control Module.

2023年11月21日 · I have a 2009 JK that is throwing a C2200 (ABS Controller failure). The Freeze frame is showing 10.66v so I think I may have a power or ground issue. I'm looking for the power and ground wires to make sure the correct voltage is making it to the controller. I've already pulled the main connector and reseated it with no change.

2021年1月22日 · No lights! No flash! So far so good. I sent this ABS module to get rebuilt because new it was around the same place but you need to pay to get it flashed, I've heard that you can get this all done for you for around $1,200 at dealership or ship but I spent $250ish on this rebuild from ModuleMaster.

2011年4月3日 · 7. Route the ABS wire over the frame near the front of the swaybar. 8. Route your ABS wire up the swaybar link using zip ties to secure it. Leave enough slack for your rotor to turn. The ABS wire should run almost all the way up the swaybar to the end depending on link lengths and lift. Connect the wires back together and engage the red lock. 9.

2019年4月19日 · The wheel speed sensors won't throw an OBD code, so it won't show up on a standard code reader. Go to AutoZone and ask for their loaner program code reader (NOT THE STORE READER). The loaner does ABS codes. I didn't even have to pay the loaner deposit, I just took it out and pulled the ABS codes in the parking lot.

2018年7月4日 · 2 weeks ago I had my ESP, BAS, ABS, Traction Control and BRAKE lights all illuminate on my 2007 JK Rubicon. Checked battery terminals, battery has 12.6V and charging @ 14+. Speedometer, and MPG are still correct, cruise control works, everything seems to work fine but I do not ignore idiot...

2022年7月29日 · Perform ABS Brake Bleed Procedure So now we're ready to perform the ABS Brake Module Bleed using OBD Jscan app. Note from original poster: This is a 2 person job, where one person will need to hold the Brake pedal while the other opens the bleeder valves. It is likely not a good idea to attempt to wedge something in your JK to hold the brake ...