2011年11月5日 · They can easily offer 250 - 260 whp out of our K20Z3's while keeping great everyday drivability plus there is no need for a built bottom end or to increase compression.

2012年10月20日 · J35 throttlebody will fit a stock k20z3 manifold but need the certain gasket or spacer and will not make much hp? Or does it need to be bored, and also does it fit the RRC manifold without bore? You need to port the manifold open to use the j35 properly. Stock is 62mm, J35 TB is 68mm.

The 2006 TSX and 2007 TSX TB is DBW and a direct fit for the 2006 and 2007 SI K20z3 engine.The TSX TB is about $550 at the dealer. It would be a great power adder if you could tune for it.Not sure if the MAF sensor would compensate fuel enough for the increase air flow.

2024年5月10日 · I've recently installed a 72mm ktuned TB. While in the process I also portmatched the intake manifold to 72 mm. My intake manifold is 2.5" and I bought an adapter that bottlenecks to my TB. I also replaced the stock injectors with TRQ 310CC injectors. I adjusted my throttle % by +44 which ktuned recommended but no luck.

2007年9月6日 · This is a work in progress, I plan to add more. Prices are per part, at MSRP, as of Date of Post. Prices are subject to change. You can find all of these parts for much much cheaper. AutoFair-Honda is a vendor here that can get these parts for you. Comments/criticism are welcome. What would you like to see added?

2013年8月15日 · The best way to find out if your TB is too small for your IM plenum is to determine what the intake manifold absolute pressure (MAP) sensor is reading (in the plenum) when you are at full throttle ( or wide open throttle (WOT) …

This OEM throttle body is from the Honda J37 V6 engine (found on the Acura ZDX & MDX). It has been found to be compatible big bore throttle body upgrade for the 8th & 9th gen Civic Si engines (K20Z3 / K24Z7) with the appropriate adapter plate. The larger inlet allows more air into the engine thus allowing more

2012年2月15日 · What is the best oem k series throttle body that will work on a k20/k24 ? An will a k24a1 work or is that drive by wire ?

Here is a kit to equip your K-series with Honda’s finest intake manifold design, and along with it, a Hybrid Racing package to make it work with your K20Z3/Z4 or K24. The RBC manifold outperforms the PRB and PRC at almost all parts of the rev range.

2020年9月18日 · FG2 K20Z3 Basemap for 3.5" Intake and 72mm TB Calibrations for FlashPro Manager - Use all calibrations at your own risk (dyno tuning recommended) 2 posts • Page 1 of 1