The MSD Digital 6 Plus uses a high speed RISC microcontroller to control the ignition’s output while constantly analyzing the various inputs such as supply voltage, trigger signals and rpm.

Built-in features on the MSD Digital-6 Plus ignition include two rotary switch adjustable rev limiters, a single-stage timing retard, a start-up timing retard, an LED fault display, EMI …

The MSD is programmed for operation on 8-cylinder engines. If installing the Ignition on a different style engine, the number ted by cutting the cylinder select wire loops as sho

Highly sensitive, Precise, and Accurate. Unparalleled Sensitivity and Dynamic Range. Ultrasensitive Assay Platform. © 2025 MESO SCALE DIAGNOSTICS, LLC. All rights reserved. Terms of Use | Terms and Conditions | Privacy | Contact Us | Feedback | UK Slavery Act Statement. MSD products are for Research Use Only. Not for use in diagnostic procedures.

2012年10月2日 · as far as the voltage issue goes, the msd digital 6+ get full power direct from the battery. The voltage from the ignition switch can be 12v or 7.5v or whatever.

This Tester will check the operation of all of MSD's single-channel CD Ignition Controls. Once the ignition tests good, you can continue troubleshooting and find the culprit. The Tester produces a simulated trigger signal that fires the ignition just as if the engine was running.

2005年3月16日 · I am wiring the Big Stuff 3 efi into a MSD Dig 6+ box. I am using a MSD Crank Trigger with the BS3 and a MSD 85805 dist for cam sensor for the BS3. I am assuming that I use the white wire "points" for the MSD box because the BS3 is using a white wire "points also"

2009年1月21日 · I want a higher power ignition, but I don't know where to go from here because I had so many problems with the Dig 6. I had the Dig 6 checked out by MSD and they said it was %100 fine.

2009年8月22日 · 325 windser woulnt rev under load, thought it was msd dig 6, got it checked out, its OK. timing was all over so pulled msd dist. and gear was wiped and gear on FMS Z cam also. msd says high volume oil pump caused it I dont buy that. what do you think caused it? motor had about 30 runs on it. going to tear motor down to clean and swap cam and dist gear. gear was steel and cam was hydrolic ...

2004年11月17日 · I have a GT with some bolt ons like MSD dig 6 plus box, MSD wires, MSD distibutor, MSD coil, MAC long tubes, MAC hpipe with cats, MAC dumps, Pro M 75 mm MAF, 65 mm TB, MAC cold air intake, hypertech chip, underdrive pullies. That is most of the bolt ons I can think of that would affect smog.