There are 3 mazda 626's in my family, and we have had little trouble ('94 DX auto, '96 LX auto, and '97 LX std). Recently, the auto trans in the 96 died - locked up and would not move. No previous indication of problems (no leaks or power loss).

mazda alternator belt fell offi have mazda 1991 626 regular ,manual Iwas driving and alternator belt fell off and i replaced it and car doesnt start. Battery is new and alternator just replaced,what could be?.power is ok (sparks are fine , gas is ok)Any ideas Thanks in advance

I am planning to buy a 2002 mazda 626 with 60000 miles but I after reading forums I noticed many 626 mazda had transmission problems. Learn more about Mazda at the Edmunds.com Car Forums! Read real discussions on thousands of topics and get your questions answered.

My 2001 Mazda 626's thermostat has been fluctuating down to C for the last three days. I noticed it 4 days ago. I turned the car on in the evening (in the 50s out) and the needle sat on C for several miles (longer than ususal) and then slowly came up to just below the half way mark.

I have a 2000 mazda 626, automatic. the car was bought used. due to a leak ,there was no gas in the compressor when the car was bought. after fixing the leak and gas added the AC was working but after working for about 45munites and u drive to a halt the compressor will be cutting and picking within seconds. this will eventually lead to the engine going off. due to this problem i …

94 Mazda 626, 2.0 liter, manual transmission Answered 21 views 2 comments 0 points Most recent by dwaymich August 2018 Mazda Mazda 626 will start sometimes

I am working on a 93 v6 mazda 626 that will not start, took out a spark plug, it fires nice bright blue, took off fuel line at fuel rail has fuel when cranking, checked throttle position sensor, checked crankshaft position sensor down by pulley,Haynes manual shows wiring for 4 and 6 wire mass air flow sensor but this one has 5 wires, it has symptoms of cold start not working if you …

I have a 1999 Mazda 626 LX with the 4 cylinder and auto trans. We just bought it from my wife's grandmothre and it has basically been sitting for the last 7 years. I drove it back to Colorado from California at the end of October. On the trip I noticed the lights were pulsing. Not completely off and on, but definately bright, dim, bright.

Hello, I have a 1993 Mazda 626 which has developed a engine idle surging and cutting off problem. I originally thought that it was a transmission issue, which needed repair anyways, but that has been fixed and the issue is still there.

2022年10月20日 · this is simple on my p-reg 626 1.8gxi. I've worked for Mazda during this period so here goes... 1. slacken the nut down the side of the handbrake lever, removing small plastic trim if required. 2.