2005年11月26日 · Hey guys, I have a P0102 error, MAF sensor, low air input /circuit something or other. Air filter is not bad, I figure, maybe some contaminent on the MAF, which I will be cleaning later on, but I am curious, if I wanna run a test on the MAF to see if …

2017年5月20日 · Latest update. The check engine light did come back on and when I hooked up my Vag Com I got a P0101(implausible signal). So I took that MAF out and put the original MAF back in after cleaning it completely. Went for a drive and got the P0102 code again. Getting tired of messing with it, I bit the bullet and bought a new MAF from my local dealer.

2009年2月6日 · Bought this car in the fall and the day before i bought it the check engine light came on. The previous owner took it to the VW dealer here and they changed the MAF out with now success. I didn't think it was going to be hard to repair so i said just leave it. I pulled the code with a scanner i own and its a P0102 MAF Low input.

2022年5月4日 · Hi, had this code for a few months now. VCDS says Mass Air Flow Sensor P01012 000 - Signal too low other than the engine management light the car runs absolutely fine. I probed the MAF plug and here are the results for a 5 pin BOSCH plug. Engine off Pin 01 - empty Pin 02 - 0.05v Pin 03 -...

2018年10月12日 · Joined Jun 18, 2015 Location Greenville, MI TDI 2001 alh Jetta, RC2 w/.205's 5speed daily summer commuter and 2000 alh Jetta 5spd swap, 2" lift, hitch, stage 3 TDtuning w/.216's winter cruiser, 1996 Tacoma ALh

2011年6月4日 · Hello everyone, I purchased a 2006 Jetta TDi about 6 months ago and since then I’ve driven it about 25K miles. I recently decide to install a subwoofer and amplifier. After doing so, before I could even drive the car out the driveway, the CEL came on! I thought it was no big deal because I took...

2021年8月27日 · Hi there, I have a MK5 golf 1.9 TDI BKC and I am losing my mind over the MAF fault code, P0102 signal too low. I have replaced the MAF sensor and still no difference, I have checked the pins but I am not getting a 12 volts in one of the pins. Anyone know where the wire might lead too or what the...

2005年3月24日 · There seems to be a general consensus that it helps. I am concerned about the female portion of my connector since I have replaced the MAF and I still have the codes p0101 and p0102. I have ordered another MAF and I can not find the write-up anywhere for testing the female portion of this connector even though I have seen it in my searches.

2010年11月19日 · can anybody help me my with my Mass air flow sensor fault - signal too low p0102 2.0 tdi 140 Tried 3x maf senors : genuine brand new bosch brand new aftermarket and a 2nd hand No boost leaks egr cooler and egr deleted and been mapped out any help or advise will be appreciated thank you

2023年4月21日 · 1. P0102-Replaced the MAF sensor and the same code came up after clearing the codes 2. After clearing the P0228 code with the pedal unplugged the code popped up again. I plugged my pedal back in and could hear the idle go up and then back down after unplugging it. Tried a pedal that I know works and it didn't solve the issue. 3. P0571 brake switch.