2010年8月15日 · p1272 fuel rail pressure sensor in a nut shell you were giveing it some and the fuel pressure spiked in the rail above the safe zone so the computer said open the flood gates and get the fuel out (at the back of the rail is the presure release valve) and at the same time the computer said lets go to safe mode to save any further damage give the earth beside the ecu a clean it is the main earth ...

2005年8月6日 · I recently replaced my number 2 and 4 injectors as well as my IDM Now that it is back together it has a rough idle along with the SES light coming on with or without my programmer Preformance is still good but the rough idle is driving me crazy I took it to the stealer and the code P1272 came...

2014年8月30日 · Hey guys I have been having a problem with loss of power when driving and just at idle. Was also due for a service so got my uncle to plug in his scanner and came up with 2 faults just chasing some possible causes and also a diesel specialist and maybe auto elec in s.e Melbourne. Fault codes P1272 fuel rail pressure relief valve U1000 CAN comms cct

Hi, My 2008 D40 diesel Navara is spitting out fault code P1272. Car goes into limp mode with heavy acceleration. Ecu rest works for the short term, but...

2011年1月29日 · So the dreaded limp mode has struck again.. managed to read the fault code via TorquePro P1272 has anyone definitively figured out what is the cause... SCV, Fuel Pump, Rail Sensor.....

2023年10月13日 · A couple weeks ago while sitting at idle I had my check engine light come on in my 2002 F-250 and the truck started running really rough. After pulling codes there was a P1316 Injector driver code and a buzz test gave a p1272 Cylinder #2 high to low side open.

2013年2月19日 · hey guy just wondering if any has had their car go into limp more while driving? mine cut out 3 times today and i used my torque pro on my phone and said a P1272 code was coming up and it was to do with"Acceleration pedal position sensor" I match the code up with nissan and it says "air and...

2006年11月21日 · P1272-when you are checking the UVC connector, the block wire connector that you pull apart over te top of the VC, hold it upright and check the bottom row of wires for bare spots.

2012年11月17日 · You should be able to locate a generic bosch sensor from any reasonable auto electrician, not sure about Nissans, but changed the wife's Honda's oxy sensor recently, Honda wanted about $500, generic from a auto sparky was about $250. If you take your ute in they can check your old one with a oscilloscope and also cross reference the numbers on it for a generic one. It would be worthwhile ...

2007年10月6日 · 1999 F-250 7.3L PSD Intermittently over about 1-week, Service Engine light would come on while driving, run rough, then clear up after a minute or so. Started to run rough then died about a mile from home and will not run... my son borrowed a scan tool and pulled off these codes. Have reviewed...