2018年9月1日 · PERC H730 or H330. Ask Question Asked 6 years, 6 months ago. Modified 6 years, 6 months ago. Viewed 17k ...

2019年10月23日 · DELL PERC H730 RAID Performance Problems. Ask Question Asked 5 years, 4 months ago.

2018年6月12日 · Can I flash the firmware of the onboard PERC H730 mini (rebranded LSI) in a Dell R530 server? Right now, I have it in pass-through mode, which works fine, but FreeBSD doesn't get any SMART data. With normal expansion card controllers, I would flash IT mode firmware, but I'm unsure if this is even possible with this particular controller, as it ...

2020年4月19日 · PERC H730 supports two operating modes: RAID mode and HBA mode. the standard RAID mode, which supports RAID and non-RAID disks. In RAID mode, the controller expect the disks to be part of a RAID array and will not expose the …

The DELL PERC H730 is based on the LSI 3108 Chipset, and since this chipset supports disks larger than 2TB and SAS3 communications I can't see reasons for this controller won't work with those Seagate NL-SAS 4TB discs. What you should consider is the cabling used on this card, since SAS3 cards uses the new SFF8643 connector.

2022年1月24日 · I've been using Debian on Dell servers for many years. For a long time I've been using the PERC H730P RAID controller, which is well supported by utilities like MegaCLI. Recently I've bought a R440 Server with the new H750 Raid controller. I've initially been able to install Debian 11 on logical volumes created from the "BIOS" System Setup.

2021年2月11日 · I'm installing Proxmox Virtual Environment on a Dell PowerEdge R730 with a Dell PowerEdge RAID Controller (PERC) H730 Mini Hardware RAID controller and eight 3TB 7.2k 3.5" SAS HDDs. I was contemplating using the PERC H730 to configure six of the physical disks as a RAID10 virtual disk with two physical disks reserved as hot standby drives.

2018年6月21日 · In other words, are the configurations of H330 and H730 similar enough that "Import Foreign Config" will work on the H730? I can of course reformat the disk and restore from backup, but the backups are on a NAS and the full restore would probably take about three hours (this is the time required for the full backup on Sundays); and it would ...

2011年12月6日 · I was able to perform the same process adding two new drives with a Perc H310 controller on an exsisting Raid 5 configuration. I did notice that when I began to run through the Reconfigure task in the Virtual Disk settings, it defaulted to "Raid 0" - watch out.

2021年1月25日 · I have a PERC H740P that when you go F2 into the BIOS then navigate to the PERC device it says STATUS: needs attention. does anyone know how to figure out what exactly needs attention? Because I have cleared configuration and have tried to clear everything yet the thing always seems to say needs attention.