2007年8月30日 · There wwill be Semi truck pulls in Pontiac,IL. Its off of Interstate 55 to exit 197 then back east 2 miles. It starts at 5pm.

2017年8月17日 · Agreed! IMHO it'd be OK to keep it fairly stock and run it in amateur local pulls, but it'd be a sacrilege to hack it all up to be competitive as a pro puller on the circuit. Pretty expensive too... Building a top pulling semi truck will easily run into 6 figures!

2005年7月18日 · there is a long square tube with a flat plate and king pin (simmilar to a end dump trailers ) that locks into your 5th wheel, at the rear of this square tube (past the end of the truck frame) there is a vertical tube welded to the end that extends down past the frame rails. on the lower part of the square tube is a round dounut thats welded to ...

2007年12月4日 · The king pins took grease without problems, the truck only has 91k on it, I did not see any damage to any of the components on a visual inspection. I'm thinking it must be the hydraulics because it only happens when turning to the left and the engine speed does not make a difference to the effort required to get it to turn.

2006年2月28日 · BigMackTrucks.com is a support forum for antique, classic and modern Mack Trucks! The forum is owned and maintained by Watt's Truck Center, Inc. an independent, full service Mack dealer. The forums are not affiliated with Mack Trucks, Inc.

2012年8月14日 · Im curious to know what c.a.r.b.'s regulation of antique truck emissions is. since updating a antique truck to meet current emissions laws it takes away from the historical value of the truck can they force you to retro-fit current emissions standards on older trucks used for truck shows,pulls, e...

2006年6月23日 · Semi Truck Pulls. chris88 replied to Mack Doctor Jr.'s topic in Odds and Ends. Good luck with last call ...

2010年12月1日 · We put the rear in on Sat. Ran truck Mon, Tues and today. Keep in mind, back rear put in about 3 weeks ago, then tranny about 2 weeks ago and then inner rear this weekend. Truck was not run alot during that time. On Monday I was hearing a noise. Hard for me to explain these noises but will try. 3 noises all together.

2013年9月5日 · Each week I start the MH to charge the batteries and move it. After shutdown I always drain the moisture from the air tanks. Well today after I pulled the cable on the LH tank and released the cable, I could hear air continue to leak. I pulled and released the cable several times thinking the dra...

2022年1月15日 · Sir ,what you are describing in my opinion are the bushings as you have suggested.our 2 mack chs have this problem.since they were over the road and since converted to dump truck the rubber bushings don't hold up.. usually we can get a year out of them.they are not greasable ,either in the front or the back at the spring hanger.They noise is most easily heard when turning loaded.see if ...