2009年10月20日 · by Type 4 Unleashed » Thu Nov 18, 2010 9:33 pm. 1 Replies 85929 Views Last post by doc Thu Nov 18, 2010 ...

2007年9月7日 · Mobil ATF 3309 is recommended for use in transmissions made by Aisin AW requiring a fluid approved against Type T-IV, JWS 3309, GM 9986195 and Audi G-052-025-A2. These Aisin AW transmissions are used in CERTAIN domestic and foreign vehicles, including Toyota, Lexus, Audi, Saturn, Ford, Volvo, Volkswagen, Saab, Porsche, and Mitsubishi.

2017年8月26日 · 2002 Camry 4cyl with 155k miles. I have always done drain & fill with toyota type IV. I read that valvoline maxlife multi-vehicle ATF is compatible with type 4. Since I am doing drain & fill, is it OK for maxlife atf to mix with type 4? Anyone used maxlife on 02-04 Camry? Thanks

2004年1月30日 · Contact BustedBus or Ken at TheBusCo for used bus heat exchangers and all the misc parts like the tubes, air control boxes etc so it will work. You will have to cut the sheet metal in the engine bay and make a seal for the type 4 sheet metal, not too hard. Use the bus foam seal to seal the gaps.

2012年12月27日 · Dextron III / ATF Type T-IV confusion I just looked in my 1999 Lexus es300 transmission dipstick, which said ATF Type T-IV, however in the manual, it clearly says Dextron II or III equivalent. So, now I am wondering if a mechanic put the wrong fluid in, and if I should do a flush, with the correct fluid...

2004年4月23日 · T4T: 2,4ltr Type 4 Turbo engine, 10.58 1/4 mi in a streetlegal 1303 "Mine isn't turbo'd to make a slow engine fast, but to make a fast engine insane" - Chip Birks Top

2010年6月18日 · Speedy26 wrote:it's a 2000cc, 1978 type 4, has dual 44 idf's and a 4 into 1 header. the rest is all rebuilt stock.

2008年6月30日 · The VDO gauge is not marked well, it is hard to read. I carry a 300 and 350 deg temperature crayons in my bag, and I have a good quality infra-red hand-held meter. So, I'm pretty sure my head temperature is under control. Additionally, I run a Scat type-4 deep sump which probably helps too.

2010年12月18日 · I found rebuilt type 4 rigid clutches for 20$ on ebay, bad material yes, but for a stock motor, perfect. I had my input shaft bearing put in as a machine fit for 20$ from a near by fabricator named Bill at A1 Welding.

2006年7月28日 · Well, I wish I had a better answer for you, but I think the type 4 stock cooling looks terrible in a bug especially a baja with the engine exposed. Plus, I have torn the bug completely appart put in new floor pans, welded in new heater channels repainted it inside and out built my own metal fenders using superbeetle front fenders for front and ...