2010年4月16日 · You can closely approximate the velocity of factory wadcutter loads with 1.5 grs. of TiteGroup, 1.7 grs. of Bullseye or 2 grs. of 231 with the Speer, Hornady or Lapua 98-gr. HBWC bullets.

2008年8月12日 · That's good to know, zxcvbob. Thanks I'm trying to consolidate components and I'm looking for a longarm to go somewhere between the .22lr and .223 (recoil-wise). I have a S&W 52-2 pistol that also is the go between for .22lr and 9x19, I was hoping it would be possible to run .38 wadcutters in an 1894 lever. .

2007年5月24日 · Hello, Basically, what the title says: has anyone dealt with this company? Do they have a good reputation here on THR? They have some good .38 spl deals I'd like to order... Also, what brass does the Winchester super match WC use? Is it the same brass as their regular .38 spl? Thanks,

2005年2月27日 · I’m experimenting with 32 loads for my wife’s Ruger 32. As I go into light loads, “cowboy†loads, I run into 2 problems. I tried to load a wadcutter bullet in a 32 mag case but the Lee die set would not seat the wadcutter flush with the mouth of the case. I seated the bullet as deep...

2016年3月22日 · 7-shot 380 Auto with FMJ ammo, or a 5 shot .38 snubby with full wadcutters? I do believe the wadcutters will do much more damage? But is the extra 2 rounds in the 380 making up for it?

2007年11月7日 · Finally, a lot of the failure reports from 158gr lead semi-wadcutter hollowpoints (LSWC-HP) come from Winchester's recipe which has lead a bit too hard for use in 2" barrels, or the old Federal which often wasn't fast enough (Federal tends to wimp out on power levels). Test Remington's 158+P or Buffalo Bore (BuffBore either standard pressure or +P) in either plain gel or denim-wrapped gel and ...

2011年8月30日 · hello little update , finally got my bulletmould . its a lyman 150 gr wadcutter bevelbase , couldnt wait to try it ! i melted some scraplead and mixed it with some tin in a 40 to 1 mix. i scraped down a candle for fluxing the melt , parrafine does a great job , …

2017年6月4日 · The Winchester Train and Defend, I think it is, looks promising. Sometimes, esp in winter, I figure just go with a plain Jane 158 grain standard pressure semi-wadcutter and get a pretty clean .36 caliber hole deep into the target. 148 grain wadcutters are another viable option though they don't reload well from speedloaders.

2009年5月27日 · I have loaded 9mm and 45 acp using 231. I was wanting to start reloading 357 magnum and was wondering which are the best powders to use. I was going to primarily use 158gr bullets - how many grains with what powder work best.

2015年11月12日 · I'll repeat the question here for clarity: Have you ever used a hollow point or semi-wadcutter bullet in a cap and ball revolver? I'd like to know what your experience was. If you have experimented with these bullets, who made you the mold? Did you see an improvement in velocity or accuracy? Did...